Hardware Installation Guide

2.1REMOVING THE TOP PANEL

Place the case flat on an even, stable surface.

1.Remove the three thumbscrews from the rear of the top panel.

2.Grip the top panel and slide it back several inches until it stops.

3.Grip the panel from the sides and lift it up until it pulls completely free of the main chassis.

Note: Do not use your fingernails to pry or lift the panels.

2.2REMOVING THE DRIVE TRAY ASSEMBLY

Remove the top panel as detailed in section 2.1.

1.Using a Phillips-head screwdriver, remove the three screws on the top of the tray that attach it to the chassis.

2.Grip the tray in the middle and pull it a few inches toward the rear of the case until it pulls loose.

3.Pull the drive tray assembly up and completely free of the chassis.

2.3MOTHERBOARD INSTALLATION

Remove the top panel and remove the drive tray assembly as detailed in sections 2.1 and 2.2.

1.Lay the case down, with the open side facing up. The drive cages and power supply should be visible.

2.Make sure you have the correct I/O panel for your motherboard. If the panel provided with the case isn’t suitable, please contact your motherboard manufacturer for the correct I/O panel. Install the I/O panel at the rear of the case.

3.Align your motherboard with the motherboard standoff holes located at the rear of the case.

4.Screw in your motherboard to the standoffs with the provided Phillips-head screws.

Your motherboard is now installed.