NOTE
Notices
The information contained in this document is subject to change without notice.
This document contains proprietary information that is protected by copyright.All rights are reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of the Agilent Technologies.
Agilent Technologies Japan, Ltd.
Component Test
Copyright © 1990, 1998, 1999, 2000 Agilent Technologies Japan, Ltd.
Manual Printing History
The manual’s printing date and part number indicate its current edition. The printing date changes when a new edition is printed. (Minor corrections and updates that are incorporated at reprint do not cause the date to change.) The manual part number changes when extensive technical changes are incorporated.
1990 | First Edition (part number: |
November 1998 Second Edition (part number:
August 1999 Third Edition (part number:
March 2000 Fourth Edition (part number:
Safety Summary
The following general safety precautions must be observed during all phases of operation, service, and repair of this instrument. Failure to comply with these precautions or with specific WARNINGS elsewhere in this manual may impair the protection provided by the equipment. In addition it violates safety standards of design, manufacture, and intended use of the instrument.
Agilent Technologies assumes no liability for the customer’s failure to comply with these requirements.
16048A comply with INSTALLATION CATEGORY I and POLLUTION DEGREE 2 in
2