Important Mains plug wiring instructions.
The power supply unit is supplied with a moulded mains plug fitted to the AC mains power lead. Follow the instructions below if the mains plug has to be replaced.
The wires in the mains lead are coloured in accordance with the following code:
| TERMINAL | WIRE COLOUR | |
|
|
|
|
|
| European | USA/Canada |
|
|
|
|
L | LIVE | BROWN | BLACK |
N | NEUTRAL | BLUE | WHITE |
E | EARTH GND | GREEN & YELLOW | GREEN |
|
|
|
|
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or with the Earth symbol.
This appliance must be earthed.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter N.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the letter L.
Ensure that these colour codes are followed carefully in the event of the plug being changed.
Precautions
Damage :
Environment :
Cleaning :
Transporting :
DC power cable:
To prevent damage to the power supply unit cosmetics, avoid placing heavy objects on the unit, scratching the surface with sharp objects, or subjecting the power supply unit to rough handling and vibration.
Protect from excessive dirt, dust, heat and vibration when operating and storing. Avoid tobacco ash, smoke, drinks spillage, and exposure to rain and moisture. If the power supply unit becomes wet, switch off and remove power immediately. Allow to dry out thoroughly before using again.
Avoid the use of chemicals, abrasives or solvents. The power supply unit is best cleaned with a soft brush and dry
The power supply unit should be transported in the original packing or purpose built flightcase to protect it from damage during transit.
Plan the location of the mixing console and power supply unit so that the DC power cable is not fully extended. Full extension of the cable can stress the mixing console and power supply unit connectors and may result in undesired performance. Ensure that the power cable is located such that it cannot be stood on or tripped over.
4 | RPS14 User Guide |