9. USING FOOT PEDAL AND REMOTE CONTROL
USING FOOT PEDAL
Place the foot pedal on the floor in front of the machine.
Once all correct settings are displayed, you may use the foot pedal to operate the laminator for “Hands Free
Operation.” To activate the machine, press the foot pedal once and then release. Repeat to stop the rollers.
USING REMOTE CONTROL | 1 | 2 | 3 |
|
|
|
|
Located on the left hand side of the rear of the laminator, to use press:
1.RUN : To activate the rollers.
2.STOP : To stop the rollers from turning.
3.REV : To reverse the rollers. Press and hold the button (useful for jams or
10. USING CROSS CUTTER
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to the center of the completed application at the desired point of detachment (Figure 1).
Figure 1
2. Grasp film with one hand, press the cutter
downward into the application and slide it first to one
Figure 2 end of the application, then to the other end to
complete the cut (Figure 2 & 3).
Figure 3
9
RSS, RSR, RSH Series
11. USING SLITTER
Only the RSR & RSS series have slitters included
1. Adjust the left and/or right slitters by loosening the slitter adjuster knob (located between the front and rear rollers.) Figure 1
Figure 1
2. Activate the slitter by turning the slitter knob(located on the left side of the machine) clockwise. Figure 2
Figure 2
3.Once you activate the slitter then you can begin lamination. Figure 3
Figure 3
4. To deactivate the slitter turn the slitter knob counterclockwise. Figure 4
Figure 4
NOTE: When the slitter becomes dull break off the blade. Loosen the screw to pull down a new blade. Once the new blade is down tighten the screw.
Figure 5
Figure 5
CAUTION
When the slitters are not in use please keep the slitters positioned at the far left and right side to avoid injury.
10