6. Features Guide
Power Switch 1
Located on the rear of the machine. “I” (on) “0” (off). (Fig. 2)
Cross Cutter 2
Used to cut off the laminated web. (Fig. 2)
Feed Guide 3
The feed guide permits alignment of the item(s) to be laminated. To position the adjustable guide, loosen the knob, slide it to the desired position and tighten the knob to secure the feed guide in place. (Fig. 3)
Safety Cover 4
Cover + Protect the hot rollers.
NOTE: If the safety cover is opened, this rollers stop turning.
Film Shaft and Locking Core Adapter 5
The film shaft holds the film supply on the machine. The locking core holds and locks the film on the shaft to prevent shifting. (Fig. 4)
Film Tension Adjustment 6
Allows the operator to increase or decrease roll film tension. To increase the tension turn the knob clockwise and to decrease tension turn the knob counterclockwise. (Fig. 5)
NOTE: - Excess tension on the top roll feed will cause upward curl.
-Excess tension on the botton roll feed will cause downward
curl.
-Tension should be adjusted until the laminated materials exit flat.
Figure 2
Figure 3
5
Figure 4
6
Figure 5
8