SEAL 44 operation manual Unpacking and SET-UP

Page 6

UNPACKING AND SET-UP

The ProSEAL 44 is a professional laminator designed for ease of use. The process speed and temperature have been preset to eliminate operator guesswork. The factory setting will facilitate good quality results using the ProSEAL Flexible Pouches and Pouch Boards.

The ProSEAL 44 can handle Flexible Pouches and Pouch Boards up to 44 inches (1120mm) wide.

Please familiarize yourself with machine operation before installation, operating the Control Panel and the Nip Control Knob.

Installation of your ProSEAL Laminator

Please read and fully understand the entire manual before proceeding to use your laminator.

Your ProSEAL laminator must be lifted and carried to the place where it will be used. This should be done by at least two people, one on each side. Grasp the machine 8-10 inches (20cm-25cm) from the side. It should only be placed on a sturdy, clean, flat, level surface able to support 111 lbs. (50kg).

Keep the area around your laminator clear with adequate space around it so you can feed, receive and trim mounted and/or laminated images.

Unpacking your Laminator

1.Open the box, and lift the machine out (at least two persons necessary!). Grasp the machine 8"-10" (200mm-250mm) from either side, at the bottom metal parts. Be careful! The polyethylene bag is slippery!

2.Place the machine on the work area described above.

3.Remove the protective expanded polystyrene foam.

4.Remove the polyethylene bag.

5.Inspect the machine for any physical damage (if damage does exist, report this to the Freight Company or Dealer to file a claim). Contact Technical Service (see rear cover) to determine if a replacement machine should be shipped to you.

NOTICE! Retain original packaging. Failure to return machines properly packed in original packaging will impose a fifteen percent restocking fee plus costs to repair shipping damage. Contact Technical Service for Return Authorization (see rear cover).

Setting up your Laminator

The ProSEAL laminator should be installed next to a power/main outlet. If an extension cord is needed, make sure the cord rating meets or exceeds the machine rating.

The plug and the outlet must be easily accessible. Please ensure that you plug your laminator into a grounded, EARTHED, three- prong outlet. Please ensure that the total load of the other items using the same circuit breaker do not exceed its breaking value.

The US versions of the ProSEAL machines are provided with a fixed power cable and NEMA 5-15 plug.

Use 120Vac 15A or 20A grounded outlet only.

15A

or

20A

Using your ProSEAL 44

Plug the power cable into the grounded outlet with appropriate service as described above.

Turn on power with main power switch. Roller will turn continuously while power is on.

Wait 10-15 minutes to determine if the unit has achieved operating temperature Note: The LED indicator will blink until the machine is up to temperature.

When LED indicator is constantly lit, the ProSEAL laminator is ready for use.

CAUTION! Set the Nip Control Knob to the “Open” position when not in use.

NOTE: The laminator may emit vapors the first few times it is used. This is normal and will cease after several minutes of use.

ProSEAL® 44 Pouch Board Laminator

6

Image 6
Contents Owners Operation Manual ProSEAL 44 Pouch Board Laminator Table of Contents Introduction Statement of Intended USELiability Statement Important Safeguards Unpacking and SET-UP NIP Control Knob Rear PanelControl Panel Panel FunctionsMounting Using a ProSEAL Mounting Board Mounting Using a ProSEAL Pouch Board Encapsulating Using a ProSEAL Flexible Pouch Cleaning Your Laminator Trouble Shooting Guide Problem Cause SolutionSpare Parts List Glossary of Terms Technical Specifications Limited Warranty Seal Customer Service