POWER-UP and Tone Control Adjustments | Pinnacle Speakers 125, 225

POWER-UP AND TONE CONTROL ADJUSTMENTS:

∙With the VOLUME control at minimum (fully counter-clockwise) plug your subwoofer’s power cord into any ordinary wall outlet. The red power indicator LED will stay on as long as the subwoofer is plugged- in. If for any reason you do not want your subwoofer on, simply unplug it.

∙Please ensure that your receiver’s loudness control is off and that the bass tone control is in its middle (flat or no boost) position. Now play some music with ample bass content. (The following setup routine is best accomplished with one person seated in a normal listening position directing another to adjust the controls for the best sound.)

∙Adjust the VOLUME level on the subwoofer’s control panel so that the output level of the subwoofer is satisfactory (relative to your front speakers). If either of your front speakers or subwoofer are not functioning properly, please refer to the Troubleshooting section toward the end of this manual.

∙Adjust the FREQUENCY ADJUST knob and determine what position sounds best. This feature controls the output level of the mid and upper bass frequencies. Please note that if you have hooked up your subwoofer to a Dolby Digital or DTS receiver via its LFE jack, due to the low pass filter already in the receiver, the subwoofer's frequency adjust control would be best left at the highest frequency (fully clockwise).

∙Adjust the PHASE switch on the subwoofer’s control panel to determine which position sounds the most natural and powerful. The difference should be most audible in the mid-bass. If you cannot detect a difference, leave the PHASE switch in the + (in-phase) position.

∙The best VOLUME level, FREQUENCY ADJUST and PHASE switch positions will mostly be determined by your room acoustics, the mid and upper bass frequency response characteristics of your front speakers, and your personal preferences. The source material will also play a significant role as its bass level and qualities may vary considerably.

∙After your initial adjustments you may want to go back and “tweak” these controls. Their effects are acoustically interrelated. Re-adjusting them may be necessary to obtain optimal performance. Generally, once you are satisfied with your subwoofer's settings, you can use your receiver’s tone, equalizer, volume and subwoofer output level controls to optimize your whole system’s performance.