MOUNTING LOCATION
Before you start the installation, it will be necessary to find a mounting location for the ampli- fier. Find a location in which the amplifier will receive adequate ventilation in order to dissipate the heat it develops during operation. Two popular mounting locations are in the trunk or under the seat.
Select the location in which you wish to mount the amplifier. Use caution when mounting amplifier, there are many wires, gas lines, vacuum lines, brake lines as well as a gas tank in the automobile. Make sure you know where they are when mounting the amplifier to avoid puncturing lines, shorting wires or drilling holes in the gas tank. Once you are ready, use a pencil to mark the mounting holes in the bottom panel. After you have marked the locations of the holes move amplifier out of the way and drill small starter holes to make the tapping screws easier to install. Use provided screws to tighten down the amplifier.
QCA4500D 4500 Watts Dynamic Power
Class D Monoblock Amplifier
POWER CONNECTIONS
(QCA4400 QCA2500D QCA3500D QCA4500D)
SPEAKER OUTPUT | FUSES | +12V | REM | GND |
| ||||
| POWER |
|
|
|
| PROTECT |
|
|
|
QCA2500D2500 Watts Dynamic Power
Class D Monoblock Amplifier
Turn on Remote
|
| |
|
| Mounted Within 12” |
- | + | From Battery |
Recommended. | ||
94.7 | Battery |
|
+12V
IMPORTANT! Before making any connections, disconnect the car’s battery until the installation is completed to avoid possible damage to the electrical system.
Connect the amplifier to the car’s battery
At times, the amplifier will need to draw large levels of current that cannot be provided by any circuit in the car’s fuse box. We recommended using a 4 to 8 gauge power wire for your connections depending on the amplifier and length of the wire. Strip one end of the wire to connect to the terminal on the amplifier marked “batt+”. Loosen screw terminal and connect bare wire and tighten. Use caution to make sure no stray wire strands come in contact with surrounding terminals causing short circuits. Run the wire directly to the positive terminal of the car’s battery. Make sure to use an
Connect the ground terminal of the amplifier to the car’s chassis
For the ground connection, use a 4 to 8 gauge wire (black) to connect to the terminal marked “ground” and then connect it to the car’s chassis. Try to keep the length of the cable as short as possible, preferably less than 6”. Also make sure that the point on the car where the connection is to be made is free of paint and dirt.
Connect the remote terminal of the amplifier to a switchable +12V source
This connection allows the amplifier to be turned on and off with the power control of the radio. If the radio has a REMOTE output terminal, connect it to the amplifier’s terminal marked “remote” (using a 16 gauge wire or heavier). Now when the radio is turned on, the amplifier will automatically turn on. This connection can also be made to the radio’s Power Antenna wire.
5 | 6 |