EPSON AcuLaser CX11 Series Basic Operation Guide
Follow the steps below to make a copy.
1.Make sure the product is turned on and paper is loaded in the product. For details, see the User’s Guide.
2.Press the 
Copy button on the control panel.
The Copy light is lit and the LCD panel shows Copy Mode for a few seconds, and then changes to the copy mode screen.
Note:
If no button is pressed for more than 3 minutes, any changes made are canceled and the mode returns to the Print mode.
3.Place your original either on the document table or in the Auto Document Feeder (fax model only). For details, see “Setting your originals.”
4.Specify the desired copy settings if necessary. For details, see the User’s Guide.
Note:
When you press the x B&W Start or
x Color Start button without making any settings here, copying starts with the existing setting values.
5.Press the x B&W Start or x Color Start button.
To make a
Copying starts.
Note:
❏Do not turn off the power or press another mode’s button while copying is in progress, as copying may be performed incorrectly.
❏When you place multiple documents in the Auto Document Feeder and make a continuous high quality (600 dpi) color copy with the default memory (128 MB), the product may not work properly because of insufficient memory. We recommend adding an memory module so that the total memory size is 256 MB or higher.
Canceling copying
When the y Cancel button on the control panel is pressed while a document is being copied, the LCD panel shows Cancel Print Job and the copy job is canceled.
Basic Copying | 10 |