Atlona 4x2 Component Matrix Switcher with Digital/Analog Audio
RS232 - Cable Pin Lines
Baud Rate : 9600 bps, Data Bit :8
bits, Parity : None, Stop Bit :1 bit
• Each command is terminated with a Carriage Return
• Each feedback is terminated with a Carriage Return
• Code entry is CASE SENSITIVE.
• Do not insert spaces between letter/ number code entries.
Note1: Feedback for a command repeats the original command. Example, if x1$ is a command, the feedback is the same and if the command is x2$, the feedback would also be x2$.
Note2: If command fails, the feedback should be "Command FAILED”.
PROTOCOL COMMANDS
Command | Description |
| Feedback | |
|
|
|
| |
PWON | Power ON |
| PWON | |
PWOFF | Power OFF |
| PWOFF | |
All# | Reset all input signals to matching output. (Input 1 to Output 1, Input 2 to | All# | ||
Output 2, etc…) |
| |||
|
|
| ||
x1$ | Switch OFF specificed output channel [1]. If Output channel is 2 the command | x1$ | ||
| would be x2$ |
|
| |
x1AVx2 | Switch specified input to output. If input is 5 and output is 3, then command | x1AVx2 | ||
would be x5AVx3 |
| |||
|
|
| ||
x1AVx2,x3, | Switch specified input to mu ple outputs. If input is 5 and outputs are 6, 7, 8, | x1AVx2,x3,x4 | ||
x4 | then the command would be x5AVx6,x7,x8 |
| ||
Statusx1 | Display input currently routed to specified output. Example Statusx1 is asking | x7AVx1 | ||
| what input is currently being routed to Output # 1 |
| ||
|
|
| x1AVx1, | |
Status | Display current rou | ng for all inputs and outputs | x2AVx2, | |
x3AVx4, | ||||
|
|
| ||
|
|
| x5AVx8, … | |
Save[Y] | Save the current rou | ng to a preset command [Y]. [Y] ranges from 0 to 9 | Save2 | |
|
|
| ||
Recall[Y] | Recall the preset command [Y]. [Y] ranges from 0 to 9 | Recall2 | ||
Clear[Y] | Clear the preset command [Y]. [Y] ranges from 0 to 9 | Clear2 | ||
Mreset | Reset device to manufacture default | Mreset |
Toll free: | atlona.com |
Local: |