Adjustments and Settings, Using the Printer

SRP-350II

1-6 Adjustments and Settings

The SRP-350II is set up at the factory to be appropriate for almost all users. It does, however, offer some settings for users with special requirements.

It has DIP switches that allow you to change communication settings, such as handshaking and parity check, as well as print density.

The SRP-350II also has a near-end sensor for the paper. This can give you a warning when the paper is almost out. If you find that there is not enough paper remaining on the roll when the near-end sensor is triggered, you can change the near-end sensor setting. Rotate the near end sensor tab at front or rear position. (See the below figure)

Near end sensor tab

1-7 Using the Printer

Control Panel

○POWER

The POWER light is on whenever the printer is on.

○ERROR

This indicates an error.

○PAPER

This light indicates the near end of the paper roll. Install a new paper roll and the printer will continue printing. When the light blinks, it indicates the self-test printing standby state or macro execution Standby state when the macro execution command is used.

○FEED

Press the FEED button once to advance paper one line. You can also hold down the FEED button to feed paper continuously.

Rev. 1.00

- 15 -