UsingYour Adapter, FCC Information | Radio Shack 273-355 instruction

273-355

9VDC • 800mA

AC-to-DC Power Adapter

UsingYour Adapter

1.Plug the correct

size Adaptaplug onto the jack at the end of the adapter’s cord.

•If your device’s DC input jack is marked

, align TIP on the adapter’s jack with + on the Adaptaplug (shown).

•If the DC input jack is marked , align TIP on the adapter’s jack with – on the Adaptaplug.

wCAUTION: Be sure to set the correct tip polarity. Incorrect polarity can damage your device or the adapter.

2.Plug the Adaptaplug into your device’s DC input jack.

3.Plug the AC adapter into an easily accessible power outlet located near the equipment.

Protect the environment. Go to E-CyclingCentral.com to find an electronic recycling center near you.

Cautions:

•If this adapter is not compatible with the voltage and current requirements of your portable device, it can result in PERMANENT DAMAGE to the device.

•Before using, consult the User’s Guide or the rating label on your device to make sure it requires 9 volts DC.

•The power adapter’s current (800mA) must be equal to or more than the current needed by your portable device.

•Before charging cell phones, make sure the cell phone specifications are supported by this power adapter.

•Never operate the adapter if it has been damaged in any way. Do not disassemble it.

wWARNING: To prevent fire or shock hazard, do not expose the adapter to rain or other moisture.

wCAUTION: The total combined current for accessories plugged into this adapter must not exceed 800mA.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip- ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Modifying or tampering with your 9VDC 800mA AC-to-DC Power Adapter’s internal components can cause a malfunction, which might invalidate its warranty and void your FCC authorization to operate it.

LimitedWarranty

Ignition L.P. warrants this product against defects in materials and workmanship under normal use by the original purchaser for ninety (90) days after the date of purchase. IGNITION L.P. MAKES NO OTHER EXPRESS WARRANTIES.

This warranty does not cover: (a) damage or failure caused by or attributable to abuse, misuse, failure to follow instructions, improper installation or mainte- nance, alteration, accident, Acts of God (such as floods or lightning), or excess voltage or current; (b) improper or incorrectly performed repairs by persons who are not a Ignition L.P. Authorized Service Facility; (c) consumables such as fuses or batteries; (d) ordinary wear and tear or cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs of product removal, installation, set-up service, adjustment or reinstallation; and (g) claims by persons other than the original purchaser.

Should a problem occur that is covered by this warranty, take the product and the sales receipt as proof of purchase date to the place of purchase. Ignition L.P. will, at its option, unless otherwise provided by law: (a) repair the product without charge for parts and labor; (b) replace the product with the same or a comparable product; or (c) refund the purchase price. All replaced parts and prod- ucts, and products on which a refund is made, become the property of Ignition L.P. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period.

IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON THE EXPIRATION OF THE STATED WARRANTY PERIOD.

EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Some States do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from State to State.

You may contact Ignition L.P. at:
Ignition L.P., 3102 Maple Ave Suite 450, Dallas, TX 75201		02/09
For product support, call 1-866-315-0426.
© 2009. Ignition L.P. All rights reserved.	Printed	05A09
Enercell is a trademark used by Ignition L.P.	in China	273-355

273-355 specifications

Radio Shack 273-355 is a versatile and widely recognized component in the realm of electronics. This product has garnered attention from hobbyists, educators, and DIY enthusiasts alike due to its remarkable features, ease of use, and compatibility with a wide range of projects.

At its core, the Radio Shack 273-355 is a dual-LED (Light Emitting Diode) with an integrated circuit, designed to provide a practical solution for many lighting applications. One of the standout features of the 273-355 is its low power consumption, making it an ideal choice for battery-operated devices or systems where energy efficiency is paramount. This allows developers to create longer-lasting devices without sacrificing performance.

This component supports a broad voltage range, typically from 3V to 12V, allowing for flexibility in design and application. The dual-LED configuration provides both visual indicators and decorative lighting options. Its two colors - often red and green - can be utilized for signaling, enhancing visual interfaces, or creating engaging effects in projects.

The Radio Shack 273-355 is also characterized by its simple connections, which usually include in-line resistor requirements for limiting the current to the LEDs. This not only protects the components but also teaches users about essential circuit design practices. It can be easily integrated into various setups such as breadboards, making prototyping straightforward for both novice and experienced builders.

In terms of construction, the 273-355 LEDs feature a durable package that can withstand normal handling and soldering, which is a significant advantage for those who frequently prototype or experiment. The compact nature of the component also plays into space-saving designs, allowing users to incorporate it into tight spaces.

With its combination of longevity, flexibility, and ease of use, the Radio Shack 273-355 is an excellent choice for educators looking to introduce students to electronic concepts. Whether in classrooms, maker spaces, or home projects, this versatile LED component helps foster creativity and innovation. Overall, the Radio Shack 273-355 remains a staple in many electronic project kits and continues to inspire the next generation of electronics enthusiasts.