Powered Subwoofer

5.If the red LED is lit, try this test: Turn the "BASS LEVEL" control to "MIN". Plug a standard RCA cable into the "FROM PREAMP" jacks. Lightly touch the plug at the free end of the cable, while slowly turning the "BASS LEVEL" control clockwise. If you hear noise from the subwoofer when you touch the cable, the subwoofer is functioning. Look elsewhere in your system for the problem. If you hear no noise, contact your dealer or M&K.

6.Make sure that the input cables are OK. Double check your connections. If necessary, replace any defective cables or speaker wires.

B.If, after operating the woofer at high volume levels for a long time, the woofer cuts out or becomes intermittent:

Your subwoofer has a protection circuit that protects it from overheating. After hours of continuous operation at extremely high volume levels, this circuit may cut off the power to the subwoofer. When it activates, the sound may switch in and out rapidly, with a fluttering sound. If this happens, unplug the unit and let it sit for at least half an hour. After that time, plug it back in. It should operate normally. If you find this happens frequently, contact the factory for advice.

C.If you are using the "FROM AMPLIFIER" terminals, and the subwoofer has very little output:

Make sure that the input cables are in phase. Reverse the (+) and the ( — ) connections for ONE CHANNEL ONLY at the "FROM AMPLIFIER" terminals. If the problem remains, put the cables back as they were. Then perform the test in Step 4.

D.If the midbass range (the area of transition between Subwoofer and Satellite speakers) sounds weak:

Refer to Section 6, Phasing Test, on page 9. Reverse the (+) and ( — ) connections at the back of BOTH Satellite speakers, OR switch the "PHASE" switch from (+) to ( — ) or vice versa. The wiring configuration that gives the most bass is correct.

E.If you are using the "FROM PREAMP" input terminals, and you hear a thump through the Subwoofer every time you turn the system on:

F.If you hear a persistent hum or buzz through the subwoofer:

Because the subwoofer reproduces the 60 Hz hum frequency, it is often blamed for causing hum that originates elsewhere in the system. Always avoid running all speaker wires and RCA interconnect cables near to AC cords and component power supplies. Wires and cables running close to AC lines are a common source of hum. If necessary, reroute your cables.

To identify the source of hum, remove all input cables to the subwoofer, but leave it plugged into the AC outlet. Carefully turn the "BASS LEVEL" control up towards the "MAX" position. If you hear hum coming from the subwoofer's speaker driver, the subwoofer is the source of the hum. If you hear no hum or less hum, the problem is probably coming from another component.

Hum can also be caused by AC ground loops. If the subwoofer is plugged into a separate AC outlet, try plugging it into the same outlet used for your amplifier or receiver, or reverse the polarity of its AC plug. If these suggestions do not solve your problems, contact your dealer or M&K.

G.If there is an unusual sound coming from the subwoofer with no music playing:

Try removing the input cables as described in Step 5 above. If the noise disappears, it is coming from another component. If it does not go away, contact your M&K dealer or the factory.

VX-860, VX-850 specifications

MK Sound is a renowned brand that has long been synonymous with high-quality audio equipment. Among their impressive lineup of speakers, the VX-860 and VX-850 stand out for their exceptional performance and innovative technologies. These models cater to audiophiles and home theater enthusiasts who crave unparalleled sound quality and immersive audio experiences.

The MK Sound VX-860 is designed with a 2-way configuration, featuring a 6.5-inch woofer and a 1-inch tweeter. This speaker is engineered to deliver a wide frequency response, allowing users to experience deep bass and crisp highs. The advanced woofer design utilizes a lightweight, rigid cone that enhances sound clarity and reduces distortion. The tweeter, with its soft dome design, contributes to a smooth and detailed high-frequency response, making it ideal for both music and movie soundtracks.

In contrast, the VX-850 offers a slightly smaller 5.25-inch woofer, coupled with a 1-inch tweeter. This model is perfect for compact spaces without compromising on sound quality. The VX-850 features similar design principles to its larger counterpart, ensuring that it provides articulate sound reproduction and impressively low distortion levels. Both models boast a frequency response range that vividly captures the nuances of audio, making them suitable for various listening environments.

Technologically, MK Sound incorporates several innovative features in these speakers. One of the standout attributes is the company’s exclusive “Time Domain” technology. This proprietary system enhances imaging and soundstage by aligning the speaker's acoustical performance with the human auditory system. As a result, users enjoy a more immersive and realistic listening experience, whether they are watching movies or enjoying their favorite tracks.

The cabinets of the VX-860 and VX-850 are constructed from high-quality materials, offering excellent durability while minimizing unwanted resonances. The speakers have been designed to integrate seamlessly with various home theater setups and can be easily paired with a wide array of amplifiers and AV receivers.

In conclusion, the MK Sound VX-860 and VX-850 speakers exemplify the brand's commitment to crafting superior audio equipment. With their advanced technologies, robust design, and outstanding sound quality, these models are ideal choices for anyone looking to elevate their listening experience. Whether for music, movies, or gaming, the VX-860 and VX-850 promise to deliver an extraordinary sonic experience that captivates the senses.