Positioning your Subwoofer
Connecting the MS-8 , MS-CUBE and MS-DUO
Although the unit may be placed almost anywhere in the room, even behind the sofa or the TV set, we recommend that it be placed in front of the listener and as central to the listening position as possible. The subwoofer should not be operated within 450mm of a television set as the drive unit magnet may distort the picture.
>200mm
>200mm
The
We suggest you position the subwoofer about 20cm (8 inches) from the wall. A position close to the wall will enhance the bass; placing it across a room corner will increase the bass further, possibly at the expense of clarity. Experiment with a variety of locations and sources before making a final decision.
The drive unit and bass ports move a lot of air at high volume, so make sure you do not place your subwoofer near surfaces or objects that may rattle.
There should be a mains outlet within easy reach.
Your system will perform best if there is a clear line of sight between the subwoofer and the listening position.
A/V Processor Connections
Your subwoofer has been designed for optimum performance with a Digital processor. If your AV processor has a line level or LFE subwoofer output you should use this connection. You will need to purchase a single screened RCA phono lead from your dealer. Connect this lead to the Left line input of the Subwoofer as shown opposite.
Alternatively, you may use a split mono lead from the processor to both inputs of the subwoofer. In this case the input level at the subwoofer will be slightly higher.
AV AMPLIFIER
RIGHT LEFT | RIGHT LEFT |
REAR CENTRE FRONT
Subwoofer Out (Line Level)
RIGHT LEFT | RIGHT LEFT |
REAR CENTRE FRONT
INPUT OUTPUT
LEFT
RIGHT
INPUT OUTPUT
LEFT
RIGHT
NOTE: When running signal cables to the subwoofer, keep them clear of obstructions. Do not run a long signal cable close to mains cables or cables carrying heavy digital traffic.
Stereo Line Output Connections
If your amplifier has a spare preamplifier output or a stereo sub- woofer output, connect the
Pre Out - Main In Connections
If you use a stereo pre and power amplifier, or a stereo amplifier where the pre and main amplifier can be separated, connect the
Remove the
AV AMPLIFIER
L
R RIGHT LEFT | RIGHT LEFT |
REAR CENTRE FRONT
Stereo Outputs (Line Level)
(x2)
PRE MAIN
OUT IN
L AMPLIFIER
R
RIGHT LEFT
Speaker Level Connections
The high level Speaker connections should be used only if your amplifier does not have a line level subwoofer output. In this connection the subwoofer is fed together with the Front loudspeakers. For this you will need two extra twin core cables.
Measure out two loudspeaker cables of the appropriate length.
Prepare the cables as shown.
Connect the Left Speaker Terminals on the subwoofer to the Front Left speaker terminals on the amplifier. Connect the Red (+) speaker terminal on the amplifier to the Red (+) terminal on the subwoofer. Connect the Black
TO FRONT
SPEAKERS
AMPLIFIER
| SUBWOOFER |
SPEAKER LEVEL INPUTS | |
R | L |
8 | 9 |