Toshiba KK-1600 manual STP staple unit

Page 22

[K] STP staple unit
1.	Remove stapler. (See Fig. 6-4 to 6-7)
2.	Detach STP bottom cover R. (See Fig. 6-9)	Clamp

3.Remove STP base stay assembly. (See Fig. 6- 16 and 6-17)

4.Detach the connectors from STP controller PWA (J3/J4) and release 2 clamps.

STP controller PWA

J3

J4

327

Fig. 6-20

5. Remove 2 screws and remove STP staple unit.

STP staple unit

Screw

328

Fig. 6-21

KK-1600 DISASSEMBLY AND REPLACEMENT

6 - 6

October 2000 © TOSHIBA TEC

Image 22

Contents Toshiba TEC Corporation Contents Specifications Outline Names of Various ComponentsLayout of Electrical Parts SW2 EMPTY-SW Harness Connection Diagram Board Assembly Stpl ControllerOperational Description Block DiagramGeneral Description Cover Open/Close Detection Detection of Abnormal StatusStaple Empty Detection Flow Chart OK?Mechanism Drawing Mechanical DescriptionStaple Operation Circuit Description PWA Block DiagramFunctional Description Signal Description StpcovStaple operation When staples have run out during operation Timing ChartsStaple operation Reverse operation When the motor has locked up STP cover/STP staple cartridge Disassembly and ReplacementSTP bottom cover F Connector plate Hook Screw STP bottom cover R STP cover open switchSTP staple cover STP base stay assembly AC adapterSTP base STP controller PWASTP staple unit