Toshiba TDP-T45 owner manual Connecting a computer, Placement Styles, Operating a computer

Operating a computer using the remote control

A computer can be operated using the projector’s remote control. This function is available on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP OS, that is equipped with a USB port supporting the USB 1.1 (The mouse remote control is supported on OS 9 or OS X for the Macintosh).

The operation cannot be guaranteed for all the environments of computers.

1Connecting a computer

Connect the supplied Mouse remote control receiver to the computer.

Placement

Placement Styles

As shown in the figures below, this device can be placed in 4 different styles.

The factory setting is “floor-mounted front projection.” Set the Projection mode in the default setting menu p.33 , in accordance with your needs.

Floor-mounted front projection Floor-mounted rear projection

To USB port

Mouse remote control receiver

The remote control may fail to operate if the mouse remote control receiver is exposed to bright sunlight or fluorescent lighting.

In such a case, change position or direction of the mouse remote control receiver and retry.

Ceiling-mounted front projection Ceiling-mounted rear projection Preparations

2Operating a computer

The mouse remote control function is available when the remote control is set to [PC Mode]. (See “Switching operation modes” .)

Point the Mouse remote control at the mouse remote control receiver, and operate the remote control’s buttons.

● Moving the mouse pointer

Move the pointer control button in the direction that you wish the mouse pointer to

move, then press.

● To left click

Press the L-CLICK button.

● To right click

Press the R-CLICK button.

● To drag and drop

Move the pointer control button in a (L-)clicked state, then when the pointer is over

WARNING

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact.

Projection Distance and Size

Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for full-size picture with no keystone adjustment.)

the desired location, release the button.
● Using the computer’s up and down arrow key functions
Press the	and	buttons to switch PowerPoint® slides.

Remote Control Front Remote Control Rear

Pointer control

L-CLICK

ENTER

R-CLICK

RETURN

Screen As seen from above

90°

As seen from the side

Lens center

H

projection size (inches)

a (min length) =
			8.70844
a (max length) =		projection size (inches)
			7.50753
projection	projection distance a (ft)			height (H)
	min length		max length
size (in)				(in)
	(zooming max)		(zooming min)
40	4.6		5.3	1.6
60	6.9		8.0	2.3
80	9.2		10.7	3.1

R-CLICK

ESC

90°

a

a is the distance (ft) between the lens and the screen, and corresponds to a range of 4.6 ft to

34.4ft. H is the height from the image bottom to the center of the lens.

100	11.5	13.3	3.9
150	17.2	20.0	5.9
200	23.0	26.6	7.8
250	28.7	33.3	9.8
300	34.4

[inches]

20 21