Toshiba DP-SW25T Using handy features, Using auto setting, Correcting the keystone distortion

Using handy features

■Using auto setting

This function sets up the projector to the optimum state for	Control panel	Remote
		Control
each type of the input signal by using simple operations.

1 Press the SET UP button.

The Set up menu appears.

2 Press the SET UP button again.

The menu item is automatically adjusted/set.

For computer input, the icon will appear during processing.

For manual adjustment and setting, see the following table p.27 .

Notes

•The image may not be projected or auto adjustment/setting may not be performed correctly for input signals other than those supported by the projector p.69 , p.70 .

•Keystone adjustment cannot be corrected automatically.

●Correcting the keystone distortion

When the foot adjuster p.25 is used to change the projector placement angle while projecting the image, the picture will undergo keystone (trapezoidal) distortion. This projector is capable of correcting this keystone distortion.

Before correction After correction

●Manual adjustment

Press the SET UP button to display the Set up menu and select [Keystone]. Use

the buttons for keystone adjustment. When the adjustment is finished, press the RETURN button. The menu disappears.

Notes

•Depending on the amount of keystone adjustment and the content of images, some information may be lost, or the picture quality may suffer.

•Keystone adjustment is available for the keystone distortion in a slant angle of ±15 degrees.

●Manual adjustments and settings

The menu items of the Set up menu vary depending on the input type, as shown in

the table below.

Use the buttons to adjust the items in the table below, then press the RETURN button when you are finished.

Select Item			Description	Computer	Y/PB/PR	Video	PC
						S-video	card
Keystone	Correct the keystone (trapezoid) distortion of the			Yes	Yes	Yes	Yes
	screen.
	Screen shrinking		Screen shrinking
	downward		upward
Auto setting	Automatically adjusts items such as the sampling			Yes	No	No	No
	phase depending on the type of input signal.
	Press the SET UP button.
Phase	Adjust with		to eliminate flicker.	Yes	No	No	No
Frequency	Adjust with		to eliminate periodic patterns	Yes	No	No	No
	and flickering when many vertical lines appear
	on the screen.
Image’s	Adjust the horizontal position of the image.			Yes	No	No	No
H-position	Move left	Move right
Image’s	Adjust the vertical position of the image.			Yes	No	No	No
V-position	Move down		Move up
Clamp 1	Adjusts the clamp pulse position.			Yes	No	No	No
	Lower	Higher
Clamp 2	Adjusts the clamp pulse width.			Yes	No	No	No
	Narrower		Wider

Operations

26 27