Installing the Cable Modem
To avoid thermal problems, allow at least one inch spacing between the ventilation holes and any object to either side of the unit. It's best to have no obstructions on top of the unit. The top of the unit should be at least two inches from any obstruction.
Connect the cable modem using the following steps, referring to the figure below.
1.Connect the Cable TV coax to the input connector of a signal splitter.
2.Connect a coaxial cable from one of the output connectors of the splitter to the input connector of the television set.
3.Connect a coaxial cable from the other output connector of the splitter to the RF input connector on the cable modem rear panel.
4.Connect the
5.Connect the AC adapter to the DC IN 12V 1A jack on the cable modem rear panel. Then plug in the AC adapter to the wall electrical outlet.
6.If use the USB interface, Install the "USB Driver" following the instructions described in "Installing USB Drivers" on this manual.
10BASE-T Connection
USB Connection
Cable TV
Coax
Splitter
Television
AC Adapter | Cable | |
Modem | ||
|
The power indicator LED on the modem front panel will light, if power is present at the outlet. The modem will start operating once power is connected. No additional operator intervention is required. It will automatically find the data channel, register and connect to your computer.
Check the cable modem status. The front panel indicators (LEDs) show that the cable modem is operating properly when they are in the following condition:
POWER – lit
CABLE - lit
PC - lit
DATA - flashing or not lit
TEST - not lit
19