Toshiba SD-R6472 user manual Installation Notes, Software Driver

Page 6

SETUP – SD-R6472

Toshiba recommends that only trained professionals install this DVD Rewriteable drive into your laptop/notebook.

Installation Notes

•The SD-R6472 DVD Rewriteable drive has no jumpers that need to be set

•Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30° (drive with volume control in up position).

•When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive.

•When mounting drive, the tightening torque of the four screws must be even. Recommended screw tightening torque is 2N

•For clearance around the front bezel, it is recommended that a clearance of more than 0.8mm should be left in all directions.

Software Driver

Toshiba's SD-R6472 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the ATAPI driver from our web site.

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents DVD Rewriteable Mobile Drive Contents General Features Introduction SD-R6472Types of Disc Formats Supported Write Types of Disc Formats Supported ReadFront Panel SD-R6472 DVD Writeable Drive Front PanelInstallation Notes Software DriverUsing the DVD Rewriteable Drive SD-R6472 Removing MediaUsage Guidelines Cleaning Media Emergency EjectionHandling Media Troubleshooting SD-R6472 SolutionSpecifications -SD-R6472 CD-DA, CD+EG, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, CD-IDVD-RW DVD+R DVD+RW PerformanceCD-ROM, CD-R CD-RW Reliability EnvironmentalPower PhysicalDD4 Reset DD8 DD7 DD9 DD6DD5 DD3
Top Page Image Contents