Toshiba user manual Setup MK2018GAS HDD2168, Master/Slave Settings

Page 4

SETUP – MK2018GAS (HDD2168)

Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive.

Master/Slave Settings

Your Toshiba Hard Disk Drive can be configured as either a "Master" or "Slave" unit. Master configuration is used for all single drive applications, and master or slave configuration (only one of each per port) is used for two drive applications. Use the information in the following table before setting drive as Master or Slave.

Master configuration is obtained by setting jumpers A, B, C & D open (no jumper present). Slave configuration is obtained by setting jumpers C-D. When B-D jumper is installed, the drive is configured as cable select. If pin 28 = Low, the drive is "Master", if pin 28 - High, the drive is "Slave".

Figure 1.HDD Jumper Locations

JUMPER

P28

DRIVE

No Jumper

-

Master Drive

C-D Jumper

-

Slave Drive

B-D Jumper

LOW

Master Drive

B-D Jumper

HIGH

Slave Drive

A-B Jumper

-

Prohibit

A-C Jumper

-

Prohibit

2

Image 4
Contents Inch Hard Disk Drive Contents General Features Introduction MK2018GAS HDD2168Setup MK2018GAS HDD2168 Master/Slave SettingsInstallation Notes Placing Hard Drive inside your ComputerUsing the Hard Disk Drive MK2018GAS HDD2168 Backing up Data FilesTroubleshooting MK2018GAS HDD2168 Problem SolutionSpecifications MK2018GAS HDD2168 Physical RegulatoryInterface Connector Drive Connectors MK2018GAS HDD2168Recommended Cable Characteristics Drive Interface Signals