Toshiba user manual Drive Connectors -SD-R1512

Page 16

DRIVE CONNECTORS –SD-R1512

Figure 1.SD-R1512 Combo Drive Rear Panel - Connectors

Power

Power is supplied to your DVD drive by the connection with your computer's +5V/+12V

Connector

power cable to the power socket at the back of drive. One side of the plug has chamfered

 

edges, so the power connector fits only one way

CAUTION: Severe damage to the Drive circuits may occur if power cable is plugged in upside-down with power ON

Audio

Supplies Analog and Digital sound to your system.

Connectors

 

ATAPI

The SD-R1512 DVD drive is connected to your computer system through the ATAPI

Connector

connector

Mode

The mode select jumpers are 6 straight angle pins located on the rear of the DVD drive.

Select

By placing a jumper on the pins, you can select the following functions: CL (CSEL), SL

Jumper

(Slave) or MA (Master). (see Setup for additional information).

14

Page 15 Page 17
Image 16
Page 15 Page 17
Contents CD-RW/DVD-ROM Combo Drive Contents Types of Disc Formats Supported Write Introduction SD-R1512Types of Disc Formats Supported Read Front Panel Loading Tray Busy Light Eject Button Emergency Eject HoleSetup SD-R1512 Jumper SettingsConnecting Cables Placing Combo Drive inside your ComputerInstalling Audio Cable Completing InstallationDrive Operation Inserting a Disc Horizontally Inserting a Disc VerticallySoftware Removing a DiscUsage Guidelines Emergency Ejection Cleaning MediaHandling Media Troubleshooting SD-R1512 SolutionSpecifications -SD-R1512 General Performance CD-ROM, CD-R CD-RWPower ReliabilityEnvironmental PhysicalConnectors RegulatoryDrive Connectors -SD-R1512 Interface Pin Assignments
Top Page Image Contents