Toshiba MK6014MAP user manual Installation Notes, Placing Hard Drive inside your Computer

Page 5

Installation Notes

ƒThe drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive distortion.

ƒIn order to prevent short-circuit under any circumstances, a space of 0.5mm or more should be kept under the PCB.

ƒSpace should be kept around the drive to avoid any contact with other parts, which may occur due to shock or vibration.

ƒThe temperature of the top cover and the base must always be kept under 60C to maintain the required reliability.

ƒBe sure not to cover the breathing hole to keep the pressure inside the drive at a certain level

ƒDo not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N.

ƒThe drive contains several parts which may be easily damaged by ESD (Electric Static Discharge). Avoid touching the interface connector pins and the surface of PCB. Be sure to use ESD proof wrist strap when handling drive.

ƒThe four mounting screws should be tightened equally with 0.3N-m (3kgf-cm) torque. The depth should be 3.0mm minimum and 3.5mm maximum.

Placing Hard Drive inside your Computer

Determine mounting configuration (the drive can be mounted in either a horizontal or vertical orientation)

Configure drive for system application.

Configure the adapter board for the specific system application (if required).

Install adapter board into an unused PC/AT 16 bit slot (if required).

Install the I/F cable to the system's 44 pin connector port or adapter board. Ensure pin 1 is oriented correctly, (pin 1 on the cable is usually identified by a red or blue strip.)

Set correct drive type in system CMOS

Refer to applicable manuals for software installation instructions.

Important Note: Disconnect power from your computer system before beginning installation.

Figure 2.HDD Mounting Holes

3

Image 5
Contents Inch Hard Disk Drive Contents Introduction MK6014MAP HDD2144 General FeaturesMaster/Slave Settings Setup MK6014MAP HDD2144Placing Hard Drive inside your Computer Installation NotesBacking up Data Files Using the Hard Disk Drive MK6014MAP HDD2144Problem Solution Troubleshooting MK6014MAP HDD2144Specifications MK6014MAP HDD2144 Page Regulatory PhysicalRecommended Cable Characteristics Drive Connectors MK6014MAP HDD2144Interface Connector Drive Interface Signals