Back to Contents Page
Display Assembly
Dell™ Studio XPS™ 1640 Service Manual
Removing the Display Assembly
Replacing the Display Assembly
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside the computer.
NOTICE: To avoid damage to the display, you must not disassemble your
Removing the Display Assembly
1.Follow the instructions in Before You Begin.
2.Remove the palm rest (see Removing the Palm Rest).
3.Remove the optical drive (see Removing the Optical Drive).
4.Make note of the
5. Remove the two screws from the computer base.
6.Turn the computer over.
7.Pull the
8.Make note of the display cable, camera cable, and power/battery light cable routing and carefully dislodge the cables from their routing guides.