Rear Connection Panel
Sub Out
For systems utilizing multiple subwoofers. Connect Sub Out to the LFE Input or Right In / Left In on additional sub(s).
Right Out / Left Out
Should only be used if con- necting this sub between
a
Pass: Out control filters the output from these connections.
LFE In (Balanced)
Connect to LFE Out on your A/V processor. The subwoof- er’s Low Pass Filter control does not effect this connec- tion. Crossover settings for LFE In are controlled through the A/V processor.
LFE In
Connect to LFE Out on your A/V processor. The subwoofers Low Pass Filter control does not effect this connection. Crossover settings for LFE In are controlled through the A/V processor.
Right In/Left In
Connect to
Speaker Level In
This set of binding posts pro- vides a place to connect the subwoofer using standard speaker cable. Descent i’s Low Pass Filter control effects the signal received through these inputs.
Figure 3. Rear connection panel.
Status Light
The Descent i is equipped with a
No color: No power. The subwoofer is not plugged in, or the fuse has blown.
Green: Play mode. This indi- cates the subwoofer detects an audio signal and has auto- matically switched into play mode.
Yellow: Standby mode. This indicates the Power switch is set to Standby, or the sub has detected no audio signal for more than forty minutes and has automatically switched into standby mode.
Red: Initializing or Safe mode. This indicates that the subwoofer is initializing. This also indicates if the subwoofer temperature has exceeded nominal operating range. If the subwoofer overheats, please allow it to cool and reset it by unplugging the unit and plugging it back in.
AC Power Connection, Master Power Switch, & Fuse