MartinLogan Prodigy user manual Frequently Asked Questions

Page 22

FREQUENTLY ASKED QUESTIONS

How do I clean my speakers?

Just use a dust free cloth or a soft brush to remove the dust from your speakers. We recommend a specialty cloth (available through the XStatic shop at www.martinlogan.com) that cleans your speakers better than anything else we have ever tried. Do not spray any kind of cleaning agent on or in close proximity to the electrostatic element.

What is the advantage of ESL?

Since the polyester film diaphragm is uniformly driven over its entire surface—unlike a tweeter that is only driven at its edges—it is the only technology that can be made large enough to play bass, yet is still light enough for high frequencies. This unique property allows for the elimination of high frequency crossover points and their associated distortions.

What size of an amplifier should I use?

We recommend an amplifier with 100 to 200 watts per channel for most applications. Probably less would be adequate for our smaller hybrids or when used in home theater where a subwoofer is employed. Our hybrid designs will perform well with either a tube or transistorized amplifier, and will reveal the sonic character of either type. However, it is important that the amplifier be stable operating into varying impedance loads: a stable amplifier will be able to deliver twice its rated wattage into 4 Ohms and should again double into 2 Ohms.

Could you suggest a list of suitable electronics and cables that would be ideal for MartinLogan speakers?

The area of electronics and cable choice is probably the most common type of question that we receive. It is also the most subjective. We have repeatedly found that brands that work well in one setup will drive someone else nuts in another. We use many brands with great success. Again, we have no favorites; we use electronics and cables quite interchangeably. We would suggest listening to a number of brands—and above all else, trust your ears. Dealers are always the best source for information when purchasing additional audio equipment.

Is there likely to be any interaction between my speakers and the television in my Audio/Video system?

Actually, there is less interaction between a television and an electrostatic speaker than between a television and a conventional system. However, we do recommend that you keep your speakers at least one foot away from the television because of the dynamic woofer they employ. In the case of our center channel speakers, however, they are fully shielded and can go anywhere.

Will my electric bill go ‘sky high’ by leaving my speak- ers plugged in all the time?

No. A pair of MartinLogans will draw about 5 watts maximum. There is some circuitry to turn off the static charge when not in use; however, the actual consumption will remain close to the same. The primary purpose of the sensing circuitry is to prevent dust collection on the electrostatic element.

If the diaphragm is punctured with a pencil, stick, or similar item, how extensive would the damage to the speaker be?

Our research department has literally punctured hundreds of holes in a diaphragm, neither affecting the quality of the sound nor causing the diaphragm to rip. However, you will be able to see the actual puncture and it can be a physical nuisance. If this is the case, replacing the electrostatic transducer will be the only solution.

Will exposure to sunlight affect the life or performance of my speakers?

We recommend that you not place any loudspeaker in direct sunlight, as the ultraviolet (UV) rays from the sun can cause deterioration of grill cloth, speaker cones, etc. Small exposures to UV will not cause a problem. In general, the filtering of UV rays through glass will greatly reduce the negative effects on the electrostatic membrane itself.

22 Frequently Asked Questions

Image 22
Contents O D I G Y TM Contents Installation in Brief Installation in BriefAssembly Assembly Introduction IntroductionOperation AC Power ConnectionSignal Connection Break-InBi-Wire Connection Single-Wire Connection Passive Bi-AmplificationOperations Bass Control Switch High AmplifierPlacement Enjoy Yourself Final PlacementExtra Tweak Tonal BalanceTerminology Room AcousticsYour Room Rules of ThumbDipolar Speakers and Your Room Solid FootingControlled Vertical Dispersion Dispersion InteractionsControlled Horizontal Dispersion Three Major Types of DispersionDispersion Interactions Subwoofer Home TheaterHome Theater Electrostatic Advantages Electrostatic AdvantagesCrossover point 2-5kHz Full Range OperationTweeter Midrange Woofer Crossover point 100-400Hz Crossover point 250HzForceForwardTM Bass Alignment Martinlogan ExclusivesCurvilinear Line Source Clstm Vapor Deposited FilmElectrostatic Loudspeaker History Electrostatic Loudspeaker HistoryElectrostatic Loudspeaker History Frequently Asked Questions Frequently Asked QuestionsFrequently Asked Questions Troubleshooting TroubleshootingService SpecificationsWarranty and Registration General InformationGlossary of Audio Terms Glossary of Audio TermsGlossary of Audio Terms R T I N L O G a N