Dell 5810 owner manual Re-seat all power and data cables

2,3

2,4

2,5

A possible Motherboard, Memory, or CPU failure has occurred

A possible coin cell failure has occurred.

System is in Recovery Mode

Check the PSU cabling to Motherboard to make sure that all cables are installed correctly.

If two or more memory modules are installed, remove the modules, then reinstall one module and restart the computer. If the computer starts normally, continue to install additional memory modules (one at a time) until you have identified a faulty module or reinstalled all modules without error.

BIOS checksum failure was detected and the system is now in recovery mode.

2,6

2,7

A possible processor failure has occurred

Memory modules are detected, but a memory power failure has occurred.

Re-seat the processor

If two or more memory modules are installed, remove the modules, then reinstall one module and restart the computer. If the computer starts normally, continue to install additional memory modules (one at a time) until you have identified a faulty module or reinstalled all modules without error.

3,1

3,2

3,3

PCI device configuration activity	Remove all peripheral cards from
is in progress or PCI device	the PCI and PCI-E slots and
	reboot the computer. If the
failure was detected.
	computer boots, add the
	peripheral cards back one by one
	until you find the bad one.
A possible HDD or USB failure	Re-seat all power and data cables
has occurred.	to HDD’s. Reinstall all USB
	devices and check all cable
	connections.
No memory modules installed	If two or more memory modules
	are installed, remove the
	modules, then reinstall one
	module and restart the
	computer. If the computer starts
	normally, continue to install
	additional memory modules (one

58