Communications - Integrated LAN
NOTE: MT supports full height card, DT supports low profile card or full height card with optional riser. SFF supports low profile card.
Integrated Intel® 82578 Gigabit Ethernet LAN 10/100/1000 | MT |
| DT |
| SFF |
|
|
|
|
| |
External Connector Type |
|
| RJ45 | ||
|
|
|
| ||
Data Rates supported |
| 10/100/1000 Mbps | |||
|
|
|
|
|
|
Controller Details |
|
|
|
|
|
|
|
| |||
Controller bus architecture (example PCIe 1.0a x1) | Intel Gigabit LAN Connect Interface | ||||
| (GLCI) and LAN Connect Interface (LCI) | ||||
|
|
|
| ||
Integrated memory |
|
| N/A | ||
|
|
|
| ||
Data transfer mode (example |
|
| N/A | ||
|
|
|
|
| |
Power consumption (full operation per data rate connection speed) |
|
| 781mW | (Max.) | |
|
|
| |||
Power consumption (standby operation) with WOL enabled |
| 200mW (Max, 100Mb) | |||
|
| 66mW (Max, 10Mb) | |||
|
|
|
| ||
Power consumption (standby operation) with WOL disabled in BIOS |
|
| 0mW (Max) | ||
|
|
|
| ||
Power consumption (standby operation) with WOL disabled with driver |
|
| 47mW (Max) | ||
|
|
|
| ||
IEEE standards compliance (example 802.1P) |
| 802.3 |
| ||
|
|
|
| ||
Hardware Certifications (example FCC, B, GS mark…) |
|
| N/A | ||
|
|
| |||
Boot ROM Support |
| EEPROM (located in SPI) | |||
|
|
|
|
|
|
Network Transfer Mode (example Full Duplex, Half Duplex) |
|
|
|
|
|
|
|
|
|
|
|
Network Transfer Rate (example |
| 10 Mb | |||
| |||||
| 100 Mb | ||||
| |||||
| 1000 Mb | ||||
| |||||
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|
|
Environmental |
|
|
|
|
|
|
|
| |||
Operating temperature | 0° C to 85° C (32° F to 185° F) | ||||
|
| ||||
Operating humidity | 20% to 80% | ||||
|
| ||||
Operating System Driver Support | Windows XP | ||||
| |||||
|
|
| Win7 64Bit. | ||
|
|
|
| ||
Manageability (examples WOL, PXE..) |
|
| WOL, PXE 2.1 | ||
|
|
|
| ||
Management Capabilities Alerting (examples ASF 2.0 AMT…) |
|
| iAMT6.0 | ||
|
|
|
|
|
|
1This term does not connote an actual operating speed of 1 Gb/sec. For high speed transmission, connection to a Gigabit Ethernet server and network infrastructure is required.
OptiPlex 980 Technical Guidebook | Page 24 |