Emerson PA350-120U quick start What’S In The Box, Installation, Controls And Indicators

Top of UPS

Site Wiring Fault Indicator (Amber)

PowerSure™ PST

Quick-Start Guide for 350-500VA; 120V

WHAT’S IN THE BOX

•Quick-Start guide

•PowerSure family user manual on CD (also at www.liebert.com)

•Warranty card

•RJ-11 cord, 7 ft. (2.1 m)

•USB cable, 6 ft. (1.8m)

For more details, refer to the PowerSure user manual on CD.

Para una información más detallada, consulte el manual del usuario de la familia PowerSure en el CD.

TOP OF UPS		LEFT SIDE OF UPS		Power cord
	Output receptacles			6.5 ft. (2m)
	(surge protection			Data Line
	only)			Protection
			Cautionary Markings	Connectors
			Refer to Bottom for
	Power ON/OFF/		Circuit	RIGHT SIDE OF UPS
	Alarm Silence		protector
	Utility Indicator*
Output receptacles	(Green)
	Site Wiring Fault Indicator
(battery backup and			USB port
	(Red)
surge protection)
	Fault Indicator* (Red/Green)

INSTALLATION

Read all safety, installation and operating instructions in the PowerSure family user manual on the included CD or at www.liebert.com before operating the UPS. Adhere to all warnings on the unit and in the manual.

1.Install the UPS indoors in a controlled environment, where it cannot be accidentally turned off. Place it in an area of unrestricted airflow around the unit, away from water, flammable liquids, gases, corrosives and conductive contaminants. Maintain a minimum clearance of 4 inches (100mm) on each side of the UPS. Maintain an ambient temperature range of 32°F to 104°F (0°C to 40°C).

2.Plug the PST’s power cord into an AC outlet. Check the Site Wiring Fault Indicator on the rear; if it is illuminated, refer to the Troubleshooting section.

3.Plug any computers and monitors into the orange receptacles for battery backup and surge protection; other office machines that do not exceed the capacity of the UPS may be plugged into either of the two (2) black receptacles, which provide surge protection only.

4.Connect Phone/Fax/DSL/Internet/Modem devices to data line connectors.

Plug this type of equipment into black receptacles ONLY

Inkjet Scanners Fax

printersmachines

Plug computers, monitors, routers and cash registers into orange receptacles

5.Press and release the ON/OFF/Alarm Silence button to turn on the UPS. The UPS will beep and the Utility Indicator will illuminate (green).

6.Turn on connected equipment.

CONTROLS AND INDICATORS

This button controls output power to the connected load and has three functions:

•Turns the PowerSure PST ON •Turns the PowerSure PST OFF •Silences PowerSure PST alarms

TURN THE UPS ON: Press and release the main ON/OFF button to start the UPS. An audible alarm will sound briefly.

TURN THE UPS OFF: When the PST is ON, hold the main ON/OFF button down for more than 2 seconds to shut it down. An audible alarm will sound briefly.

SILENCE AN ALARM: When a UPS alarm is active, press and release the main ON/OFF button to silence the audible alarm (Excep- tions: low battery, overload and overtempera- ture). DO NOT hold the button down for more than 2 seconds or the PST will shut down.

CHECK THE PST’S CONDITION: Three sta- tus indicators on the front of the UPS illumi- nate to specify the status of the UPS (see Troubleshooting section for details).

SITE WIRING FAULT INDICATOR (AMBER)

The Site Wiring

Fault Indi-

cator on the top of

thePST, as shown,

illumi-

nates amber when the UPS detects a line- neutral reversal or a poor neutral-ground. (See Troubleshooting Chart if indicator is illuminated.)

SPECIFICATIONS

Model Number	PA350-120U	PA500-120U
Model Rating VA / W	350/225	500 / 300
DIMENSIONS: in (mm)
Unit W x D x H	6.6 x 9.8 x 3.7	6.6 x 9.8 x 3.7
	(168 x 250 x 95)	(168 x 250 x 95)
Shipping W x D x H	9.4 x 13.8 x 5.6	9.4 x 13.8 x 5.6
	(238 x 350 x 142)	(238 x 350 x 142)
WEIGHT: lbs (kg)
Unit	11.7 (5.3)	13.5 (6.1)
Shipping	12.1 (5.5)	13.9 (6.3)
INPUT AC PARAMETERS
Surge Protection	603J
Voltage Range Without	98VAC - 140VAC ±3VAC
Battery Operation
Frequency	57 - 63 Hz (±0.4Hz)
Input Power Cord	6.5 ft.attached, w/ NEMA 5-15 P
OUTPUT AC PARAMETERS
	(3) NEMA 5-15R (orange) battery
Output Receptacles	backup+surge protection
	(2) NEMA 5-15R (black) surge
	protection
Voltage (Battery Mode)	120VAC ±8%
Output Current	2.9 A	4.2 A
Waveform (Battery Mode)	Stepped Sinewave
Frequency (Battery Mode)	60Hz ±1Hz
Overload Warning	>100%
Overload Shutdown	>110%
BATTERY PARAMETERS
Type	Valve-regulated, nonspillable, lead
	acid
Quantity x Voltage x Rating	1 x 12V x 5 Ah	1 x 12V x 7 Ah
Transfer Time	4 – 6 ms typical
Back-up Time:	At 77°F (25°C), resistive loading, w/
	fully charged batteries:
Full load	5 minutes	3 minutes
Half load	16 minutes	15 minutes
Recharge Time	12 hours to 90% capacity, after full
	discharge into resistive load

ENVIRONMENTAL

Operating	+32°F to + 104°F
Temperature	(0°C to +40°C)
Storage	+5°F to + 122°F (-
Temperature	15°C to +50°C)
Relative	0% to 95%, non-
Humidity	condensing
Operating	Up to 10,000 ft.
	(3000 m) at 86°F
Elevation	(30°C) w/o
	derating
Audible Noise	< 40 dBA, at 1
	meter
AGENCY
Safety	UL 1778, c-UL
	Listed
	ANSI C62.41,
	Category A, Level
Surge	3, (IEEE 587,
	Category A);
	EN61000-4-5,
	Level 3, Criteria A
ESD	EN61000-4-2,
	Level 3, Criteria A
Susceptibility	EN61000-4-3,
	Level 2, Criteria A
Electrical Fast	EN61000-4-4,
Transient/Burst	Level 3, Criteria A
Emissions	FCC Part 15,
	Subpart B,
	Class B
Harmonics	EN61000-3-2
Conducted	EN61000-4-6
Immunity
Flicker	EN61000-3-3
Transportation	ISTA Procedure
	1A

COMMUNICATIONS

The PowerSure PST has a USB interface port for communication that will work with the built-in Microsoft Power Manager software on the user’s PC, if the PC is so equipped. It will provide UPS status and man- ages the automatic, orderly shutdown of the computer. The UPS (USB) communications meets HID stan- dard, version 1.11. All USB models are compatible with Microsoft Windows 2000, Windows XP and Mac OS 10.2 or later. All USB models ship with a 6 ft. (1.8m) USB cable.