D-Link DWL-900AP specifications Antenna

Page 2
When connecting the DWL-900AP+
Wireless Access Point to an Ethernet Adapter in a computer, use a Cross- Over Ethernet cable.

Connecting The DWL-900AP+ Wireless Access Point To Your Network

A. First, connect the power adapter to the receptor at the back panel of the DWL-900AP+ and then plug the other end of the power adapter to a wall outlet or power strip. The Power LED will turn ON to indicate proper operation.

B. Using a Straight-Through Ethernet cable, insert one end of the cable to the Ethernet port on the back panel of the DWL-900AP+ and the other end of the cable to an Ethernet Broadband Router (i.e., D-Link DI-604) or Switch (i.e., D-Link DSS-5+). Note: The router

or switch must be connected to the computer to be used to configure the DWL-900AP+. The Link LED light will illuminate to indicate a proper Ethernet connection.

C.Computers with 802.11b wireless adapters can connect to the DWL- 900AP+. The DWL-650+ AirPlus Wireless Cardbus Adapter and the DWL-520+ AirPlus Wireless PCI Adapter will connect, out of the box , with the DWL-900AP+, using their default wireless settings.

C. Antenna

Used to wirelessly

connect to

802.11b adapters.A. Receptor for Power

Adapter

Reset Button

B. Ethernet Port

Pressing this button

restores the DWL-

This is the connection for

900AP+ to its original

the Ethernet Cable to the

factory default

Ethernet port on the

settings.

Ethernet Broadband

 

Router or Switch.

Image 2
Contents Check Your Package Contents Before You BeginAntenna Using The Setup Wizard Using The Setup Wizard Wireless Setup Your Setup is Complete You will be returned to the Home tabClick Exit Technical Support