NETGEAR WG602 manual FCE-Konformitätserklärung, Statement of Conditions

Page 14

FCE-Konformitätserklärung

Für folgendes Gerät:

 

 

 

 

 

 

 

 

 

 

 

 

 

54 Mbps Wireless Access Point

 

 

 

 

0768

!

 

 

 

 

(Produktname)

 

 

 

 

 

 

 

 

 

 

WG602

(Modellbezeichnung)

wird hiermit bestätigt, dass das Gerät den Anforderungen der Richtlinie zur Angleichung der Rechtsvorschriften der Mitgliedstaaten in Bezug auf Elektromagnetische Verträglichkeit (89/336/EEC), Niederspannung (73/23/EEC) und der abgeänderten Verordnung (93/68/EEC) entspricht. Für die Bewertung der Richtlinien wurden folgende Standards angewandt:

ETS 300 328:1996-11+A1:1997-07

ETS 300 826:1997-11

EN 60950:1992+A1:1003+A3:1995+A4:1996+A11:1997

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

Certificate of the Manufacturer/Importer

It is hereby certified that the Model WG602 54 Mbps Wireless Access Point has been suppressed in accordance with the conditions set out in the BMPT- AmtsblVfg 243/1991 and Vfg 46/1992. The operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in the operating instructions.

Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and has been granted the right to test the series for compliance with the regulations.

VCCI Statement

This equipment is in the Class B category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council for Interference by Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in such residential areas. When used near a radio or TV receiver, it may become the cause of radio interference. Read instructions for correct handling.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2.This device must accept any interference received, including interference that

may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Modifications made to the product, unless expressly approved by NETGEAR, Inc., could void the user's authority to operate the equipment.

Federal Communications Commission (FCC) Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.

Canadian Department of Communications Radio Interference Regulations

This digital apparatus (Model MA401 Wireless PC Card) does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department

of Communications.

25

26

Image 14
Contents WG602 System Requirements Package ContentsIntroduction Placement and Range Guidelines WG602 Wireless Access Point Front PanelWG602 Wireless Access Point Rear Panel Default Factory SettingsInstall the WG602 54 Mbps Wireless Access Point Access PointFeature Default Factory Setttings Wireless Access Point Configure Basic Setup Parameters Setup OptionsLogin to the Access Point Setup IP Settings Configuration DescriptionWireless Settings Configuration Description Security Settings Configuration DescriptionConfiguration Description Access Control ListChange Password Default NoAdvanced Options Enabling Basic Wireless Access Security Features Protecting Your Wireless NetworkSecurity Configuration Change the Wireless Network Name Ssid Change the Default PasswordSecure the Access Point Restrict Wireless Activity by MAC Address TroubleshootingConfigure WEP Encryption Problem Cause SolutionDéclaration de conformité CE Mbps Wireless Access PointCE Declaration of Conformity WG602FCE-Konformitätserklärung Statement of ConditionsTechnical Support Support Information