NETGEAR WG302v2 manual Industry Canada Compliance Statement

Failure to follow these guidelines can result in significant performance degradation or inability to wirelessly connect to the wireless access point.

RF Exposure Warning for North America, and Australia

WARNING! To meet FCC and other national safety guidelines for RF exposure, the antennas for this device (see below) must be installed to ensure a minimum separation distance of 20cm (7.9 in.) from persons. Further, the antennas shall not be colocated with other antenna or radio transmitter.

Antenna Statement for North America and Australia

In addition to its own antenna, the WG302v2 device has been approved for use with the following detachable antennas and antenna cables.

Approved	Antenna Gain and	Approved Antenna	Antenna Cable	Maximum Transmitted
Antennas	type	Cable	Length	Powera
NETGEAR	14.5 dBi, directional	NETGEAR ACC-10314-	1.5 m to 30 m	18 dBm + 14.5 dBi ant.
ANT24D18v2	outdoor/indoor	01 thru 05
NETGEAR	9 dBi,	NETGEAR ACC-10314-	1.5 m to 30 m	18 dBm + 9 dBi ant.
ANT2409	omnidirectional	01 thru 05
	outdoor/indoor
NETGEAR	5 dBi, ceiling/wall	NETGEAR ACC-10314-	1.5 m to 30 m	18 dBm + 5 dBi ant.
ANT24O5	indoor	01 thru 05

a. WG302v2 maximum radiated power in North America and Australia: 19 dBm – cable loss + antenna gain

Please see the product specifications at http://kbserver.netgear.com/products/wg302.asp for an updated list of wireless accessories approved to be used with the WG302v2.

Industry Canada Compliance Statement

This Class B Digital apparatus meets all the requirements of the Canadian Interference Causing Equipment Regulations ICES 003.

Cet appareil numerique de classe B respecte les exigences du reglement du Canada sur le materiel brouilleur NMB-003.

The device is certified to the requirements of RSS-210 for 2.4 GHz spread spectrum devices. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information, contact your local Industry Canada office.

iv

v1.0, May 2006