D-Link DI-704 user manual

Page 28

6.The TCP/IP protocol shall be listed in the Network window. Click OK to complete the install procedure and restart your PC to enable the TCP/IP protocol.

B.2 Set TCP/IP protocol for working with the DI-704

1.Click Start button and choose Settings, then click Control Panel.

2.Double click Network icon. Select the TCP/IP line that has been associated to your network card in the Configuration tab of the Network window.

3.Click Properties button to set the TCP/IP protocol for the DI-704.

4.Now, you have two setting methods:

20

Image 28

Contents Link Limited Warranty Ninety 90 days Wichtige Sicherheitshinweise Trademarks Copyright Statement CE Mark WarningVcci Warning Table of Contents Introduction Access Control supported Virtual Server supportedUser-Definable Application Sensing Tunnel DMZ Host supportedFront Panel Hardware InstallationRear Panel Page Page Network Settings and Software Installation Page Configuring The DI-704 Page Page Page Static IP Address Dynamic IP AddressPPP over Ethernet Dial-up NetworkPage Page Page Default Page Appendix a Console Mode Appendix B TCP/IP Configuration for Windows 95/98 Page Get IP via Dhcp server Page Page Appendix C Technical Specifications Offices Registration Card Print, type or use block letters