Placement Positions, Horizontal Placement

Chapter 1

Product Overview

Placement Positions

There are two ways to physically install the device. The first way is to place the device horizontally on a surface. The second way is to mount the device on a wall.

The best place for the device is usually at the center of your wireless network, within range of all of your wireless devices.

Horizontal Placement

The device has four rubber feet on its bottom panel. Place the device on a level surface near an electrical outlet.

Wall-Mounting Placement

The device has two wall-mount slots on its bottom panel. The distance between the slots is 152 mm (6 inches).

Two screws are needed to mount the device.

Suggested Mounting Hardware

4-5 mm	1-1,5 mm	-3,0 mm
		2,5

††Note: Mounting hardware illustrations are not true to scale.

NOTE: Cisco is not responsible for damages incurred by insecure wall-mounting hardware.

Follow these instructions:

1.Determine where you want to mount the device. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet.

2.Drill two holes into the wall. Make sure the holes are 152 mm (6 inches) apart.

3.Insert a screw into each hole and leave 3 mm (0,12 inches) of its head exposed.

4.Maneuver the device so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the device down until the screws fit snugly into the wall-mount slots.

152 mm

Wall Mounting Template

Wireless ADSL2+ Modem Router