Linksys WRT54G2 manual FCC Statement, FCC Radiation Exposure Statement, Safety Notices

Page 31

Appendix D

Regulatory Information

Appendix D: Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or devices

Connect the equipment to an outlet other than the receiver’s

Consult a dealer or an experienced radio/TV technician for assistance

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.

Safety Notices

Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.

Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003 and RSS210.

Operation is subject to the following two conditions:

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device. This device has been designed to operate with an antenna having a maximum gain of 2dBi. Antenna havingahighergainisstrictlyprohibitedperregulations of Industry Canada. The required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP is not more than required for successful communication.

Industry Canada Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Wireless-G Broadband Router

27

Image 31
Contents User Guide Copyright and Trademarks About This GuideIcon Descriptions Online ResourcesTable of Contents Appendix D Regulatory Information Front Panel Placement PositionsHorizontal Placement Chapter Product Overview152 mm Wall-Mounting PlacementGeneral Network Security Guidelines Chapter Wireless Security ChecklistAdditional Security Tips Internet Setup Chapter Advanced ConfigurationHow to Access the Web-Based Utility Setup Basic SetupPPPoE Static IPTelstra Cable Optional SettingsNetwork Setup Setup DdnsDynDNS.org Setup MAC Address CloneSetup Advanced Routing MAC Address CloneAdvanced Routing Wireless Basic Wireless SettingsDynamic Routing Wi-Fi Protected Setup Basic Wireless SettingsMethod #1 Method #2 Wireless Wireless SecurityWireless Security Security ModeWPA2 Enterprise WPA2 PersonalWireless MAC Filter Wireless Wireless MAC FilterAdvanced Wireless VPN Passthrough Security FirewallFirewall Security VPN PassthroughTo create an Internet Access policy Internet AccessBlocked Services Port Triggering Applications and Gaming Port Range ForwardPort Range Forward Applications & Gaming Port TriggeringApplications and Gaming QoS Applications and Gaming DMZQoS Wireless QoS Administration ManagementRouter Password Administration Diagnostics Administration LogAdministration Factory Defaults Administration Config Management Administration Upgrade FirmwareStatus Router Local Network Status WirelessWireless Status Local NetworkYour computer cannot connect to the Internet Appendix a Troubleshooting WRT54G2 Appendix B SpecificationsObtaining Warranty Service Limited WarrantyExclusions and Limitations Technical Support Industry Canada Statement Safety NoticesFCC Statement FCC Radiation Exposure StatementAvis d’Industrie Canada Wireless DisclaimerDansk Danish Miljøinformation for kunder i EU Regulatory Information Norsk Norwegian Miljøinformasjon for kunder i EU Regulatory Information