NETGEAR EX6100 manual Install the WiFi Extender, Place the Extender and Apply Power

Page 5

Install the WiFi Extender

Place the extender, apply power, and connect it to your WiFi network.

Place the Extender and Apply Power

1.Place your extender in the same room as your WiFi router.

Note: Proximity to the WiFi router is required only during the initial setup process.

2.Plug the extender into an electrical outlet.

The Power LED lights green. If the Power LED does not light, press the Power button.

3.Make sure that the switch on the extender is set to Extender.

Connect to an Existing WiFi Network

To extend the range of your WiFi network, you must connect the extender to your existing WiFi network. You can do this in one of two ways:

Connect with WPS. For more information, see Connect with WPS on page 6.

Connect with genie Smart Setup. For more information, see Connect with NETGEAR genie Smart Setup on page 8.

5

Image 5
Contents EX6100 WiFi Range Extender Installation Guide Getting Started WiFi Range ExtenderFront Panel and Side Panel Meet Your ExtenderLED Descriptions Place the Extender and Apply Power Install the WiFi ExtenderConnect with WPS Page Connect with Netgear genie Smart Setup Page Page Page Extender Performance Find the Best LocationConnect an Ethernet-Enabled Device Set up the extender Install the Extender as an Access Point  To install the extender as an access point  To log in to the extender after the initial setup Access Extender SettingsFrequently Asked Questions Page Support
Related manuals
Manual 47 pages 381 b