User Guide
Troubleshooting
If you experience any problems with the module, check the following items before contacting Accton Technical Support:
•Ensure the switch with the fiber optic module is powered up.
•Ensure that the device attached to the module is powered up and operating correctly.
•Ensure that the module is properly seated in the slot.
•Verify that the module port is configured to match the communication mode used by the attached device (full or half duplex).
•Check the connectors on both ends of the cable to be sure they are properly engaged. When attaching fiber cable to an
•If you are using fiber optic cable with an
•Be sure the fiber terminators are clean. You can clean the cable plugs by wiping them gently with a clean tissue or cotton ball moistened with a little ethanol. Dirty fiber terminators on fiber optic cables will impair the quality of the light transmitted through the cable.
*You may use the Cheetah ST Converter (Part Number: ST5002) to attach 62.5/ 125 micron fiber cable with an
Product Specifications
Access Method | CSMA/CD |
Ports | 1 |
Network Interface | SC connector: |
| 62.5/125 or 50/125 micron multimode fiber cable |
| 9/125 micron |
Communication Mode | Full or half duplex, |
| |
Size | 12.25 x 90.70.5 x 2.74 cm (4.82 x 3.57 x 1.08 in.) |
Power Consumption | 2.4 W maximum |
Temperature | Operating: 0 to 50°C (32 to 122°F) |
| Storage: |
Humidity | 5% to 95% |
Standards | IEEE 802.3z Gigabit Ethernet |
| ISO/IEC |
Compliances | CE Mark |
Emissions | FCC Class A |
| VCCI Class A |
| Industry Canada Class A |
| EN55022 (CISPR 22) Class A |
| |
Immunity | IEC |
Warranty | Three years |
6