Accton Technology EC3805 manual System Requirement and Installation

Page 8

Chapter 2: System Requirement and Installation

System Requirement

To access the NAT Smart Router via Ethernet, the host computer must meet the following requirements:

Equipped with an Ethernet network interface.

Have TCP/IP installed.

Allow the client PC to obtain an IP address automatically or set a fixed IP address.

With a web browser installed: Internet Explorer 5.x or later.

The NAT Smat Router is configured with the default IP address of 192.168.1.254 and subnet mask of 255.255.255.0. Considering that the DHCP server is Enable by default, the DHCP clients should be able to access the Smart Router, or the host PC should be assigned an IP address of the same subnet and related subnet mask (for example, IP address of 192.168.1.100 and subnet mask of 255.255.255.0) first for initial configuration.

After configuring the IP of host PC, you also can manage the Smart Router through a web-based manager. The ADSL Router manager uses the HTTP protocol via a web browser to allow you to set up and manage the device.

8

Image 8
Contents Installation Guide Revision History Contents Introduction Features Bridging FeaturesOverview Rear Panel System Requirement and Installation System RequirementConnecting to Adsl Modem and Client PC Page Setting up IP address of Host PC Page Page Page Page Quick Setup Using the Web-Based ManagerPage Page Page Page Dhcp Clients StatusLAN WAN Connection MAC Address CloneBridge Convert NATFirewall Vlan Page Page Igmp Snmp Port Configuration SntpSystem Logs Page System Administration Tool