Abocom UTM560 manual Start→Settings→Control Panel→Modems, Select USB V.90 Tiny Modem and click OK

Page 10

Setup Diagnostics

You can perform the following steps to check if your USB V.90 Tiny Modem is well installed.

1.Go to

StartSettingsControl PanelModems.

2.When the Modems Properties dialog box appears, select the Diagnostics tab.

3.Select USB V.90 TINY MODEM and click OK.

4.If USB V.90 TINY MODEM is not found, stop the diagnostics procedures and skip to the following section titled Uninstallation.

5.The USB modem is well installed if the information is found on the following screen. Click OK to exit.

- 6 -

Image 10
Contents USB V.90 Tiny Modem FCC Regulatory Statements CTR 21 pan-European Certification Table of Contents Specifications IntroductionSystem Requirements Hardware Installation Software Installation Installation for WindowsPage Start→Settings→Control Panel→Modems Select USB V.90 Tiny Modem and click OKInstallation for Windows Click Finish Setup Diagnostics Installation for Windows Millennium Specify the location of the driver Advanced and click NextPage Page Start Settings Control Panel Modems Internet Access Go to My Computer Select Dial-Up NetworkingNow, you are ready to connect to the Internet