ADTRAN 340 Specifications, 10/100BASE T Ethernet Connector Pinout, Adsl Connector Pinout

Quick Start Guide

	For more detailed documentation, visit us online at www.adtran.com
INSTALLING THE NETVANTA 340 ROUTER	P/N 1200422L1

SPECIFICATIONS

Interfaces ADSL: RJ-11; Ethernet: RJ-48C

Compliance FCC Part 15, Class B; ACTA/FCC Part 68; UL 60950, Industry Canada CS-03, CNA/CSA C.22.2, No. 60950

Environmental Operating Temperature: 0°C to 40°C Storage Temperature: -20°C to 85°C Relative Humidity: 8 to 100% non-condensing

Power	120 VAC, 60 Hz, 65 mA, double insulated
10/100BASET ETHERNET CONNECTOR PINOUT
Pin	Name	Description
1	TX1	Transmit Positive
2	TX2	Transmit Negative
3	RX1	Receive Positive
6	RX2	Receive Negative
4, 5, 7, 8	—	Unused
ADSL CONNECTOR PINOUT
Pin	Name	Description
1-2	—	Unused

3T ADSL Tip

4R ADSL Ring

5-6 — Unused

NETVANTA 340 LEDS

For these	This activity…	Indicates that…
LEDs…
Power		Unit is powering up. On power-up the Power LED blinks
	Green (blinking)	rapidly for five seconds, during which time the user may
		escape to boot mode.
	Green (solid)	Power is on and self-test passed.
	Red (solid)	Power is on, but the self-test failed or the boot mode (if
		applicable) code could not be booted.
Ethernet	Green (blinking)	LAN activity is present (traffic in either direction).
	Green (solid)	Powered device is connected to the Ethernet port (i.e., link
		integrity).
	Off	There is no LAN activity on the Ethernet port (or modem is
		powered off).
DSL	Off	Modem power is off.
	Green (blinking)	Attempting DSL sync.
	Green (solid)	DSL link is up and everything is operational.
	Red (solid)	DSL connection failure.
Internet	Off	Modem power is off, modem is in bridged mode, or ADSL
		connection is not present.
	Green (blinking)	IP connected and IP traffic is passing through the device (in
		either direction).
		IP connected (the device has a WAN IP address from IPCP or
		DHCP and DSL connection is up) and no traffic is detected. If
	Green (solid)	the IP or PPPoE session is dropped, the light remains green if
		an ADSL connection is still present. Light turns red when it
		attempts to reconnect and DHCP or PPPoE fails.
		Modem attempted to become IP connected and failed (no
	Red (solid)	DHCP response, no PPPoE response, PPPoE authentication
		failed, no IP address from IPCP, etc.).

Additional information is given in the NetVanta 340 Hardware

Installation Guide available online at www.adtran.com.

Quick Start Guide, 61200422L1-13C, December 2004 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright © 2004 ADTRAN, All Rights Reserved