24Patch Release Note
PCR: 01272 | Module: SWI | Network affecting: No |
A physical port could not be | ||
This issue has been resolved. |
| |
PCR: 01273 | Module: SWI | Network affecting: No |
The CREATE CONFIG command now includes the STPFORWARDING parameter in generated scripts. The SHOW SWITCH command now displays the setting of STPFORWARDING.
PCR: 01274 Module: SWINetwork affecting: No
Refinements were made to the switch chip register settings improving CoS provision with the newer revision of switching silicon on the Rapier 16, Rapier 24 and Rapier 48.
PCR: 01275 Module: FIREWALLNetwork affecting: No
The firewall was incorrectly forwarding multicast packets originating from a private address in cases where a matching route was defined. This issue has been resolved.
PCR: 01276 Module: SWINetwork affecting: No
When the speed of one or more switch ports was forced to a half duplex setting and the ports were then added to a trunk group configured for full duplex operation, the port settings were not overridden by the trunk group speed setting. The trunk group speed setting will now take precedence over the port speed setting.
PCR: 01287 Module: OSPFNetwork affecting: No
Configuring IP route filters did not stop flooding of AS external LSAs to neigbours at startup. The result was that the neigbour received the AS LSAs and added the corresponding routes into its own routing table. However, after some time (e.g. 1 hour), the AS external LSAs in the neigbour’s database disappeared, but the corresponding routes were still in its routing table. This issue has been resolved.
PCR: 01289 Module: VRRPNetwork affecting: No
The checksum in VRRP advertisements was not being calculated correctly. The calculation was not compatible with the RFC. This issue has been resolved.
PCR: 01290 Module: PPPNetwork affecting: No
When PPP was running over Ethernet to a client from another vendor, the
Maximum Transmission Unit value for the link was not adjusted from the
PPP default of 1500 to 1492. This issue has been resolved.
PCR: 01291 Module: IPG(IGMP)Network affecting: No
IGMP did not send the Start Up Query, and the Other Querier Present Timer did not change the Time Out value accordingly if Query Interval was changed. IGMP did not notify other registered parties (PIM and DVMRP) when a port was deleted from a membership group. IGMP reported a membership leave to other parties while it was still waiting for a reply to a group specific query from a leaving member. These issues have been resolved.
Patch