Allied Telesis AT-AR300 manual Release Note

Page 36

36	Release Note

The LOGIN parameter is used to specify whether or not users with a privilege of “user” will be able to login to the command line interface. Usernames with LOGIN set to TRUE can be used both for PAP and CHAP authentication, and to login and access the command line. Usernames with LOGIN set to FALSE can only be used for PAP and CHAP authentication.

After upgrading from 2.0.x or 2.1.x to 2.3.x, the LOGIN parameter is required. If it is not set in a boot script, its value defaults to TRUE, allowing users with a privilege level of “user” to access the CLI. The manager then has the option of denying access to some or all users.

Software Release 2.3.1 C613-10325-00 REV B

Image 36

Contents Software Release Introduction Hardware PlatformsRapier i Series Hot Swapping Network Service Modules Hot swap an NSM out of an NSM bay Software Features Example output from the Show Interface command NSM Hot Swap Software SupportDomain Name Server Enhancements DNS CachingServer Selection Automatic Nameserver Configuration Telnet Server Port NumberTriggers for Ethernet Interfaces Enco Channels IP Security IPsec Source Interface Enhancements Ospf on Demand Isdn Paladin Firewall Enhancements Interface-based NATRule-based NAT New Command Syntax Time Limited RulesRelease Note Software Release Web Redirection with Reverse NAT Rules Required parameters for Firewall NAT rules ParametersFurther Examples Firewall and IPsec TunnelStandard NAT Paladin Firewall Http Application Gateway Proxy Show OutputFirewall Http Proxies and Firewall Policies Http FiltersADD Firewall POLICY=zone1 HTTPFILTER=banned.htp Http Cookies Firewall Policy Debugging Show Firewall PolicyVrrp Port Monitoring Http Proxy Filter FileWhere Stepvalue is a decimal number in the range 1 to Border Gateway Protocol 4 BGP-4 IP and Interface Counters Internet Protocol IPTo reset IP interfaces, use the command Example output from the Show IP COUNTER=INTERFACE command Example output from the Show IP COUNTER=SNMP command Telephony PBX Functionality Bandwidth Limiting Errata Telnet ServerInstallation Enable Telnet ServerRelease Note