Hifionics BRE2500.1D, BRE100.2, BRE60.4 manual BRE1100.1D / BRE1600.1D Mono Amplifier Applications

BRE1100.1D / BRE1600.1D MONO AMPLIFIER APPLICATIONS

Basic application

Interconnect cable checklist:

-Connect the line inputs to a Radio/CD RCA outputs or line output of the full range primary amplifier with good quality RCA cables. A “Y” adapter may be needed as shown in the diagram.

-Use at least 16 gauge speaker wiring. These amplifiers have dual speaker terminals, simplifying the hookup of multiple speakers. The 2 positives are the same and the 2 negatives are the same.

Crossover frequency control checklist:

-LOW PASS: 35Hz to 250Hz

-SUBSONIC:15 Hz to 35 Hz

-BASS EQ: 0 to 10dB

-PHASE: 0 to 180 degrees

Minimum final loudspeaker impedance: - 1 ohm.

FULL RANGE
STEREO LINE INPUT	Y-ADAPTOR

NOT USED

Note: You can use the Radio/CD designated mono line output *or a full range stereo line output. For full range stereo line output,

you will need an optional “Y-Adaptor” as shown

Level control checklist:

-Refer to the section “Setting up systems after installation for best performance”

*DESIGNATED

MONO LINE INPUT

BOOST

HFR -3 MIN MAXX

R	L	INPUT
R	L	OUTPUT
9V 0.2V		INPUT	BALANCED
		LEVEL
0 180		PHASE
		REMOTE
0dB 10dB		BASS EQ
15Hz 35Hz		SONIC	SUB
35Hz		LOW
250Hz		PASS
PROTECT		POWER

BRUTUS

ELITE

		MONO
		SUBWOOFER
		1-OHM MINIMUM
	+
	OUTPUT +
	SPEAKER -
	-
	FUSE
INPUTPOWER	REMGNDBATT+12V	CHASSIS GROUND
		TO BATTERY +12v
		VIA FUSE
		REMOTE TURN-ON

Dual Subwoofer Application

PARALLEL MONO

SUBWOOFERS

2-OHMS SVC EACH MINIMUM, or 4-OHMS DVC EACH MINIMUM

*DESIGNATED

MONO LINE INPUT

BOOST

HFR -3 MIN MAXX

R	L	INPUT
R	L	OUTPUT
9V 0.2V		INPUT	BALANCED
		LEVEL
0 180		PHASE
		REMOTE
0dB 10dB		BASS EQ
15Hz 35Hz		SONIC	SUB
35Hz		LOW
250Hz		PASS
PROTECT		POWER

BRUTUS

ELITE

	+	MONO
	OUTPUT +
		SUBWOOFERS
	SPEAKER -
	-
	FUSE
POWERINPUT	REMGNDBATT+12V	TO BATTERY +12v
		CHASSIS GROUND
		VIA FUSE
		REMOTE TURN-ON

6