3Com 3C13636 manual Upgrading the Boot ROM program

Page 22

3Com Router 3000 Ethernet Family

3. Starting and Maintaining the Router

Installation Guide

Step 3: Change your terminal’s baud rate to the same baud rate for software downloading (115200 bps in this example). After that, disconnect the terminal ([Dial-in/Disconnect]), reconnect it ([Dial-in/Dialing]), and press <Enter> to start downloading. The system displays:

Downloading ... CCCCC

Note:

The new baud rate takes effect only after you reconnect the terminal emulation program.

Step 4: Select [Transmit/send file] in the terminal window. The following dialog box pops up:

Figure 3-6Send File dialog box

Step 5: Click <Browse>. Select the application file to be downloaded and set protocol to XModem. Click <Send>.

Step 6: After completing downloading, the system begins writing data to the Flash, and then displays the following information in the terminal interface, indicating completion of the downloading:

Download completed.

Writing to flash memory...

Please wait,it needs a long time .Please wait...

####################################################### Writing FLASH Success.

Please use 9600 bps.Press <ENTER> key to reboot the system.

Restore the speed of the console terminal to 9600 bps as prompted, disconnect and reconnect the terminal. The system starts up normally.

3.2.2.2Upgrading the Boot ROM program

Step 1: Enter the Boot Menu, and then select <7> to enter the Boot ROM operation sub-menu.

Step 2: Enter <1> in the Boot ROM operation sub-menu to upgrade the Boot ROM program using XModem. Several speed options are available for you. The subsequent steps are the same as those described in “3.2.2.1 Upgrading an application program” of this section.

3-8

Image 22
Contents 3Com Router 3000 Ethernet Family Installation Guide 3C136363Com Corporation Campus Drive Marlborough, MA 01752-3064 Table of Contents 3Com Router 3000 Ethernet Family Product Overview IntroductionHardware Features of the 3Com Router 3000 Ethernet Family Appearance3036 System specificationsLEDs DescriptionInterface attributes Installing the Router Safety PrecautionsPlacing the Router on a Tabletop/Workbench Installing the RouterMounting the Router on a Vertical Surface AC-input power supply Connecting the Ground WireConnecting the Power Cord Connecting the AC-input power cordConnecting the console cable Connecting the Router to a Console TerminalConsole cable Connecting an Ethernet cable Connecting the Router to LANEthernet cable Verifying Installation Setting terminal parameters Setting up a Configuration EnvironmentConnecting the router to a console terminal Starting and Maintaining the Router3Com Router 3000 Ethernet Family 5Setting the terminal type Powering on the Router Boot Menu Maintaining the RouterFei0 Upgrading Programs through XModem Upgrading an application programUpgrading the Boot ROM program Upgrading the extended segment of the Boot ROM program Upgrading Application Programs with NET Press Enter as prompted to have the router reboot Troubleshooting the Configuration System TroubleshootingTroubleshooting the Power System SymptomsRecovering/Replacing a Lost Boot ROM Password