Replacing the Batteries

T572InstDS-150-E.Q33J1999/4/260:57PM y [ W 12

When starts blinking on the LCD panel, replace the batteries as soon as possible.

If [BATT] and light on the LCD panel, operation will stop. Replace the batteries immediately. If the recorder does not function normally after the batteries have been replaced, see “RESET” on

page 32.

USING THE AC ADAPTER

SETTING THE CLOCK AND ID NUMBER

Once the clock and the user’s ID number have been set, the user ID of the person creating the mes- sage and the time of the day are automatically recorded in the message header. To ease manage- ment of recorded messages, it is recommended that the clock and a 4-digit ID number be set before- hand.

Follow the procedure below to set the clock:

3 4

ERASE SP DICT

ERASE SP DICT	ERASE SP DICT
MENU	MENU

INDEX/

SP	DICT
ERASE
	INDEX/
	FOLDER
REC	STOP
REC

Plug the optional AC adapter into a house- hold power outlet and connect the power plug to the recorder’s power connector (DC 3 V)

Sas shown in the illustration. Do not con- nect the AC adapter to the recorder during recording. Always stop recording before con- nection. Otherwise it may not be possible to play back the voice data being recorded.

ERASE SP DICT

INDEX/

ERASE SP DICT

INDEX/

REC STOP

Warning

Misuse of the AC adapter can result in damage, fire or electric shock. Always use the dedicated AC adapter. Never use an adapter with different polarity or output voltage.

Stop the recorder before disconnecting the AC adapter.

When not using the recorder, always disconnect the AC adapter from the power outlet.

1In the Stop mode, press and hold the MENU switch J for at least 2 seconds. The menu will be dis-

played on the LCD panel 3.

2Turn the MENU switch's up/down controlJ in the up direction within 4 seconds to display the [Date] and [Time].

3Press the MENU switch again. The cursor will blink in the year position.

4 Press the MENU switch's up/down control to change [Year].

5 When the correct year is displayed, press the MENU switch. The blinking cursor moves to the [Month] position.

6 Follow the same procedure to set [Day], [Hour] and [Minute]. When the clock setting is completed, press the MENU switch to enter the ID number setting mode. (To set only the ID number, see page

14.)

7 If ID number setting is not required, press the STOP button N instead of the MENU switch after clock setting. This completes menu setting and restores the Stop mode. (When the STOP button is

pressed, the clock starts counting seconds.)

XAll settings are automatically canceled after three minutes if no further operation takes place.