Limit Search
A limit search lets you search for active frequencies between upper and lower limits that you set.
1.Press PROGRAM, then LIMIT. Lo appears on the display.
2.Enter the lower limit of the frequency range you want to search.
3.Press WX/E, then LIMIT. Hi appears on the display.
Note: If the frequency you entered is not a valid frequency, Error appears. To enter a different frequency, start again from Step 2.
4.Enter the upper limit of the frequency range.
5.Press WX/E, then LIMIT. Lo and the lower limit frequency appear on the display.
6.Press t to search from the upper to the lower limit, or s to search from the lower to the upper limit. The current monitor memory number starts flashing at the top of the display.
7.When the scanner stops on a transmission you want to save, press MONITOR to store the frequency in the current monitor mem- ory. The monitor number then stops flashing.
8.Press either t or s to continue the search. If you saved a frequency in a monitor memory, then the monitor memory number on the dis- play advances by one and starts flashing again. (If the last monitor memory was 6, the scanner returns to monitor memory 1.)
9.To hold the frequency, press LIMIT.
To exit the hold mode and resume the limit search, press LIMIT again.
Notes:
•You can press t or s during the hold mode to step through the frequencies toward the upper or lower limits.
•If you tune to a search skip frequency, the display shows L/O (see “Search Skip Memory”).
20