Radio Shack PRO-2018 owner manual 52%+#.#6745, Gnc

Special Features

±"016'"±"

•WX alert is only for receiving a weather alert.

•When the scanner detects a 1050 Hz alert tone, WX alert activates and you hear a weather alert.

%JCPPGN "(TGSWGPE["*/*\+

6162.525

7162.550

9:"#.'46

Your scanner's WX alert warns you of serious weather conditions by sounding an alarm if a National Weather Service broadcaster in your area broadcasts a weather alert tone.

To set the scanner so it sounds an alarm when a weather alert tone is broadcast, press PRI/ALERT while you are listening to the WX channel. 7B;hjýappears.

If the scanner detects the weather alert, it sounds an alarm. The scanner sounds the alert for five minutes after it receives a weather alert signal. After five minutes the alert stops and the scanner beeps every ten seconds. Press any key to turn off the alarm. To cancel the weather alert operation, press PRI/ALERT again. ±

52'%+#."('#674'5

&GNC[

Many agencies use a two-way radio system that has a period of several seconds between a query and a reply. To avoid missing a reply, you can program a 2-second delay into any channel or frequency. When your scanner stops on a channel or frequency with a programmed delay, :BOý appears and the scanner continues to monitor that channel or frequency for 2 seconds after the transmission stops before it resumes scanning, searching, or tuning.

You can program a 2-second delay in any of these ways:

•If the scanner is scanning and stops on an active channel, quickly press DELAY/´ before it resumes scanning.

•If the desired channel is not selected, manually select the channel, then press DELAY/´.

•If the scanner is searching or tuning, press DELAY/´. :BO appears and the scanner automatically adds a 2- second delay to every transmission it stops on in that band.

To turn off the 2-second delay in a channel or for all frequencies, press DELAY/´ while the scanner is monitoring that channel or frequency. :BO disappears.

20