Radio Shack PRO-2048 owner manual Direct Search

6.When the scanner finds an active frequency, you can do one of the following:

•To store the displayed fre- quency into the current moni- tor memory, quickly press

MON.

•To continue the search, press D or —.

•To hold the frequency, press LIMIT. -H-appears.

Press LIMIT again to cancel the hold and resume the limit search.

Notes:

•If you press D or — during the hold mode, the frequency changes in the current step increment toward the upper or lower limit (see “Specifica- tions” on Page 42).

•If you tune to a search skip frequency, the display shows LOCKOUT (see “Search Skip Memory” on Page 22).

Direct Search

A direct search lets you specify a starting frequency, then search for active transmissions above or below the specified frequency.

Note: You can also use the scan- ner’s delay feature while using direct search (see “Using the 2-Second De- lay” on Page 27).

Follow these steps to search for ac- tive frequencies using a direct search.

1. Press MANUAL.

2.Using the number keys, enter the frequency (including the dec- imal point) you want to start the search from, or the channel number containing the starting frequency.

3.Press D to search up or — to search down starting from the specified frequency or channel.

-d-, SEARCH, and s or t appear, and the next available monitor memory flashes.

Note: If you enter an invalid fre- quency, Error appears. Re- peat Steps 2 and 3.