Honeywell manual Ethernet Cable Kit for UDC 2500/3200/3500, Contents, Step Action

Ethernet Cable Kit for UDC 2500/3200/3500

Document Number: 51-52-33-143

Effective: 2/07

Supersedes: 8/13/04

Summary

This kit lets you connect an Ethernet cable from your UDC controller to a hub or PC.

Contents

1 Ethernet RJ45 Cable, 2 Tie Wraps

Table 1 UDC2500 or UDC3200 procedure

Step

Action

1

Figure 1 UDC2500/3200 terminal connections

If you have:

MDI-compliant hub with straight-through cable or PC with crossover cable

then make these connections:

	UDC Terminal	UDC Signal Name	Wire Color	RJ45 Socket Pin #	Hub/PC Signal Name
	Position 14	Shield	Black/Bare	Shield	Shield
	Position 15	RX-	Orange	6	TX-
	Position 16	RX+	White/Orange	3	TX+
	Position 17	TX-	Brown	2	RX-
	Position 18	TX+	White/Brown	1	RX+
2	If you have PC with straight-through cable then make these connections:
	UDC Terminal	UDC Signal Name	Wire Color	RJ45 Socket Pin #	PC Signal Name
	Position 14	Shield	Black/Bare	Shield	Shield
	Position 15	RX-	Brown	2	TX-
	Position 16	RX+	White/Brown	1	TX+
	Position 17	TX-	Orange	6	RX-
	Position 18	TX+	White/Orange	3	RX+
3	Secure cable to controller by attaching tie wraps through the holes in the controller flange.

Page 1 of 2