BX30 Owner’s Manual
|
| Figure 4. Output control and connectors | |
|
|
| |
CROSSOVER | High Pass: | Changes round the OUT line signals between : | |
|
| Direct: The signal on XLR IN connectors is directed to the XLR OUT. | |
|
| 95 Hz: The signal on XLR IN runs through a 95 Hz high pass filter, before it is | |
|
| send to the XLR OUT. | |
|
|
| |
IN | L and R : | Balanced line signal input. | |
|
| Pin 1 : Ground | |
|
| Pin 2 : Non inverted (hot) | |
|
| Pin 3 | : Inverted (cold) |
|
|
| |
OUT | L and R: | Balanced line signal output. | |
|
| Pin 1 | : Ground |
|
| Pin 2 | : Non inverted (hot) |
|
| Pin 3 | : Inverted (cold) |
If CROSSOVER High Pass is set on 95 Hz and the BX30 is turned off, the relays in the amplifier will change and thereby the OUT signal will disappear.
8