PROGRAMMING THE TIMES OF THE ALARMS
•Press MODE button to view the ALARM 1 or ALARM 2 modes. If the ALARM 1 is selected, the default time “6:00” with the ALARM 1 label will be displayed. If the ALARM 2 is selected, the default time”8:00”with the ALARM 1 label will be displayed
•Press and hold 
or two seconds - the hour digit will flash
•Enter the hour using DOWN
•Press 
button - the minute digits will flash
•Enter the minutes using DOWN
•Press 
button again. The minute digits for snooze interval will flash
•Enter the desired interval in minutes (from 1 to 59) using DOWN
•Press 
button confirming the ALARM 1 time is set.
•Use the same procedure for setting the time for ALARM 2
ACTIVATING OR DEACTIVATING THE ALARMS
•At any time press 
or 
to activate or deactivate applicable alarm
•When ALARM 1 and ALARM 2 are disabled, an applicable icon
or
disappears from the unit’s display.
SNOOZE
When any alarm sounds, press the SNOOZE/LIGHT button to temporarily stop the alarm. After the SNOOZE / LIGHT button are depressed, the alarm sound will resume in the programmed snooze period.
If the alarm is not disabled after that, it will sound for four more minutes and then will stop by itself.
13
PROJECTION
The Color Changing Projection Clock is capable of projecting the information for a limited time, as well as continuously.
LIMITED TIME PROJECTION
•Press SNOOZE/LIGHT button once to project the current time image for five seconds.
PM
• Press FLIP button to rotate projected image 180° clockwise
PM
• Press and hold FLIP button for 2 seconds again and the projected image will rotate between the time and indoor temperature information every 5 seconds
14
CONTINUOUS TIME AND TEMPERATURE PROJECTION
•Connect AC/DC adapter provided to the AC adapter input to project the time and/or temperature image continuously.
•Slide the CONTINUE PROJECTION switch to the arrow direction shown on the unit’s side: the current time will be projected on the wall or the ceiling continuously.
PROJECTING IMAGES IN DEFFERENT COLORS Your Color Changing Projection Clock designed with an ability of changing the projected image and the display backlight color.
NOTE: This feature can be activated only if an AC adapter is connected (Continues Time and/or Temperature Projection mode).
There are two options available – projection and backlight
15
with continuous color change and a projection and backlight in only one selected color.
The default option is continuous color change.
BACKLIGHT
There are two different options of using a backlight in the Color Changing Projection Clock:
•When the AC adapter is not connected, the backlight feature is activated in blue color for 5 seconds when the LIGHT/SNOOZE button is pressed.
•When the AC adapter is connected and CONTINUE PROJECTION switch is in ON position, the backlight color will change along with the color of the projected image
PRECAUTIONS
This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:
•Do not immerse the unit in water.
•Do not clean the unit with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits.
•Do not subject the product to excessive force, shock, dust, temperature, or humidity, which may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts.
•Do not tamper with the unit’s internal components. Doing so will invalidate the warranty and may cause damage. The unit contains no
•Use only fresh batteries. Do not mix new and old batteries.
•Read the user's manual thoroughly before operating the unit.
16